Infiniti Cars & Trucks - Page 6 - Recent Questions, Troubleshooting & Support
Power seats completely dead to both front seats in G35x Infiniti
If you are getting power to the switch, make sure you are getting power to the motors when the switch is moved. If so, make sure the motors have a good ground. If not, check the fuse box. If you have power to the switch and the switch is sending power to the motor and the motor has a good ground. you have a bad motor. If you have power to the switch, but are not getting power to the motor, you have a bad switch. If you don't have power to the switch, you might have a bad fuse. If you don't have power to the fuse, you might need to check a wiring diagram to see what feed power to that circuit in the fuse box.
How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe
Hi, on most vehicles, the airbag light should come on for at 6 seconds, and then go off if the system is working properly. If there is a fault or a problem in the system, the light will remain illuminated, or flash continuously. If the airbag light does not work properly, some vehicles have an audible tone that sounds indicating a problem with the airbag light system. When the light is on (or the tone is sounding), the airbag will NOT deploy, even in an accident.
<br />
The flashing light on your car is telling there is a problem.
<br />
<br />
<b>How to reset AIRBAG SRS Light on 2003 - 2006 Infiniti G35 Coupe </b>
<br />
Ignition Key Method:
<br />
<ul>
<li>Turn IGNITION on (but don't start car).</li>
<li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li>
<li>Wait 4 seconds.</li>
<li>Turn IGNITION on (but don't start car).</li>
<li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li>
<li>Wait 4 seconds.</li>
<li>Turn IGNITION on (but don't start car).</li>
<li>After the AIR BAG warning lamp lights for 7 seconds, turn IGNITION off within 1 second.</li>
<li>Wait 4 seconds.</li>
<li>Turn IGNITION on (but don't start car).</li>
<li>Wait 3 seconds.</li>
<li>Turn IGNITION off.</li>
<li>Wait 2 seconds.</li>
<li>START Car (the light may be blinking slower than before).</li>
<li>Wait 3 seconds.</li>
<li>Turn IGNITION off.</li>
<li>Wait 3 seconds.</li>
<li>START Car.</li></ul>
<br />
<b>This is a little easier</b>
To reset the light simply turn the iginition to the on position, (you dont need to start it). All the lights should stay on for thier diagnostic check. As soon as the airbag light goes off, before it starts flashing, immeditatly turn the car off. Repeat this 3 or 4 times (turning to on then off) and the light should go away
I would like to find
If the radio is not correctly working or does not start at all, check the following fuse:
• In the passenger compartment fuse box - Fuse number 6 which is a 10 Amp fuse
• In the engine compartment - check fuse box number one. In it, there will be fuse number 37, a 15 Amp fuse, replace it.
To know more about all the fuses in your car and what each does, follow this link: https://knigaproavto.ru/shemy/en/infiniti/g-series/865-2002-2007-infiniti-g35-fuse-box-diagram.html
How to replace the license plate light bulb on a 2006 infinity m35
to change the bulbs on the license plate,all you have to do is open your trunk pop out the plastic caps behind the trunk door and you do it from there its very easy.pop out whatever you need to get to the bulbs i did it. theres no need to go to the dealer for that.hope this helps. Also I purchased my bulbs simply from here:
Aliexpress Homepage
I hope this helped
99 Infiniti QX4 blower intermittently stops working
If the blower motor intermittently stops in all the speed selections. The problem will likely be the blower motor. I would not run out and buy a new motor until you inspect related components and see if you can identify other problems before ordering. It's possible that the climate control panel has a fault or the speed resistor. I would start at the blower and go to the next suspected component. If at the time the blower stops. If you tap on the blower housing and it starts to operate, that is it. Inspect the plug at the speed resistor and the blower motor. If the plugs and pins are damaged from overheating. They must be replaced before completing repairs.
Not finding what you are looking for?