Hyundai Tiburon - Popular Questions, Answers, Tips & Manuals - Page 5

Not the cam sensor, the crank sensor would do this.

It means you will either have to walk, hire a taxi, or get a friend to drive you. Seriously, if you are looking for reasons as to why your car won't start, you will need to provide a lot more information starting with Make, Model, Mileage, Maintenance history, and what happened just before it stopped running. Cheers

Check your linkages between the shifter and gearbox. Chances are one is loose.

Not sure for 98s. But you need to erase the codes to start. If the problem is still there, Check the wiring to the transmission. You need electrical diagrams.

Do you have any warning lights? A faulty camshaft or crankshaft position sensor can cause this problem. Don't just go and replace sensors - get somebody to do a diagnostic check first

left to loosen, press the helpful button and check video link below

You have a tire problem, either out of balance or a knot caused by a bad flat repair, and you can cause damage driving for a long period of time with it in that condition.

Sounds like the new clutch was not lined up properly before refitting! If it was done at a garage return it to have the clutch taken out and refitted properly by them! Or did you do it yourself?

master cyl could be losing pressure internally, if slave is dry that is most likely problem

The clutch is not disengaging completely, check adjustment

probably a faulty relay for the fuel pump

Never use spring clamps to lower a vehicle. In addition to being dangerous, they will alter you suspension geometry, completely ruin your ride quality and can easily wear out other parts of the suspension. Also, the break easily and can be noisy. Do it correctly with specially designed lowering spring and kit, (or good quality adj coil-overs) and have the wheels aligned after installing. If you need further help, reach me via phone at https://www.6ya.com/expert/daniel_4061c3d97c12c4c7

Here's a video from Scotty showing you how to replace your expansion valve,had mine replace not long ago,had Midas do mine. Replacing An Expansion Valve In Your Car ,hERE'S A NEW PART. Expansion Valve at AutoZone com Best Expansion Valve Parts for Cars Trucks...

Yes,if not,maybe a bad relay at the fans.

sounds like a bad connection or bad starter, when it runs it will heat up starter. when its cold the metal or bad connection will expand and contract. check main all connections going to starter

Corrosion of the bulb socket that holds the bulb in place. Try cleaning out any corrosion and use dielectric grease in the bulb socket. Do not use any other type of grease. If this does not work, you will have to buy new bulb sockets.

If you mean O2 sensor, bank 1 is the driver's side on RWD, or front bank on FWD. The #2 sensor is the one behind the catalytic converter, which does little but telling the ECU if the converter is doing its job.

If you paid at a legit shop, take it back. It is still under warranty.

Does it get to operating temperature? look at replacing the coolant thermostat and the engine coolant sensor. Clean the throttle body also. Inside.