Hyundai Santa Fe - Recent Questions, Troubleshooting & Support - Page 8

0helpful
1answer

Reached 40mph and loses power/ no get up and go 2002 Hyundai Santa Fe

This sounds like a plugged fuel filter or a failing fuel pump. If it has high miles a tune up including filter changes might be in order. If you have access to a pressure gauge the pressure spec. is 40-50 lbs.
2/4/2019 8:44:34 PM • 2002 Hyundai... • Answered on Feb 04, 2019
0helpful
1answer

Which 2005 Hyundai Santa Fe has a traction control button?

Most Santa Fe model from that year had traction control fitted as standard. Check the dashboard centre console. There will be a button marked like the attached image. Different car makers put them in different places. It could be anywhere from next to the gear stick to up high on the centre of the dashboard. c4890b49-4d7b-43b2-be77-b71debab0df5-k5my4cxvotf0j5wbi2dp2omj-4-0.jpeg
1/21/2019 9:21:14 PM • 2005 Hyundai... • Answered on Jan 21, 2019
0helpful
1answer

WHATS WRONG WITH MY 2002 Hyundai santa fe no issues and I driving and all the sudden it was like it shifted into neutral like nothing except park works """"HELP ME""""

First and foremost, and the obvious, check the transmission fluid. After that is noted to be full and in good condition see if there are any codes. Make note of the codes. Your vehicle has universal codes. So they can be decoded. When it does this, can you downshift and keep the vehicle moving. Very broad spectrum of possibilities.
1/14/2019 8:57:02 PM • 2002 Hyundai... • Answered on Jan 14, 2019
0helpful
1answer

I had the battery replaced in my 2007 santa fe and now the car won't come out of park. It starts but nothing else is happening.

Sounds like a ecu problem but to be sure get the OBD read and this will give you the code number for the faulty sensors,component
1/12/2019 8:21:43 AM • Hyundai Santa Fe... • Answered on Jan 12, 2019
0helpful
2answers

2007 santa fe..alarm keeps going off for no

It is most likely it is the hood switch. A vibration in the earth would vibrate the vehicle just a bit to make the hood pin not make enough contact. The pin itself would make a indentation on the rubber bump on the hood. This makes the pin not press down enough to make contact and thus made it go off.


aaea3b3.jpg
One other possibility besides the hood pin problem is when the siren assemblygoes bad. This problem surfaces when driving down the road or just sitting in front of your house. It's an internal short in the siren assembly.
12/28/2018 2:05:46 AM • 2007 Hyundai... • Answered on Dec 28, 2018
0helpful
1answer

My 2011 Santa fe is banging between 2 and 3 gears when driven a distance

I need more information if you want my help,all the best.
12/21/2018 5:42:03 AM • Hyundai Santa Fe... • Answered on Dec 21, 2018
0helpful
1answer

How do you replace evap canister on 2003 Santa Fe?

Take it to a qualified repair shop . P0455 is large evap leak , you'll replace that an the code will come back , Have a qualified shop smoke test it .
12/8/2018 11:22:51 AM • 2003 Hyundai... • Answered on Dec 08, 2018
0helpful
1answer

Remove switch panel on 2014 Santa Fe part no 93710-2w320

Wiring, schematic, electrical diagrams, torq settings, parts info, error/fault codes, full assembly/dissembly, service instructions and a lot moreetc are basic contents of these online books they here on this website https://big-manuals.com/
12/1/2018 4:50:10 PM • Hyundai Santa Fe... • Answered on Dec 01, 2018
0helpful
1answer

Location of oil pressure relieve valve 3.5 2010 santa fe

no such animal --you have a leak
11/27/2018 2:05:44 AM • Hyundai Santa Fe... • Answered on Nov 27, 2018
0helpful
1answer

2012 hyundia santa fe has a kenwood radio touchscreen i don't know my code to input after having battery out

Do you have the owners manual it usually is in it. If not contact the dealer to get code
11/19/2018 1:35:01 PM • Hyundai Santa Fe... • Answered on Nov 19, 2018
0helpful
1answer

07 santa e has no speedo on cluster but shows on scanner

vss located on top of trans near right axle output shaft for cluster speedometer ,scan tool is reading right front wheel speed sensor
11/14/2018 2:35:52 AM • Hyundai Santa Fe... • Answered on Nov 14, 2018
0helpful
1answer

My hyundia santefe 2004 has no voltage on the st sig fuse what is the effect on the car

What fault codes show in a scan?
11/12/2018 5:17:40 PM • 2004 Hyundai... • Answered on Nov 12, 2018
0helpful
1answer

Please help me to find pcv valve location on 2011 hyundai santa fe. 3.5L V6. thank you

The service and repair manual with a diagram and pictures will help you to locate and fix the problem on your own and you will get the manual from the given link http://toolsnyou.com/
11/10/2018 9:25:48 PM • Hyundai Santa Fe... • Answered on Nov 10, 2018
0helpful
1answer

2.7 santa fe engine swap cranks no start

Seems like I'm having the same problem with my 2013 Santa Fe v6 engine swapped with a 4 cylinder engine
It cranks but will not start
It started at first but now it's not working
What do I need to check
Thanks in advance
11/9/2018 11:47:52 PM • Hyundai Santa Fe... • Answered on Nov 09, 2018
Not finding what you are looking for?

6,689 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hyundai Cars & Trucks

  • Forum

View Most Popular

  • Hyundai Cars & Trucks
Loading...