Hyundai Santa Fe - Recent Questions, Troubleshooting & Support - Page 6

crankshaft position sensor...when its bad the engine shuts down..might restart after cooling off, but sensor needs to be replaced.

first check No.5 spark plug wire closely...change if necessary....if good then change crankshaft position sensor.

if its the V6 2.7l its below the coil packs and behind cooling fan(must remove to replace it) on the side of the block, Drivers side... gonna need a flashlight and long extension...kinda hidden but its there follow the wire/connector back to the block....if its 4 cylinder its passenger side behind timing belt...must remove passenger wheel and timing belt cover..

how to change the fuel filter on 2007 hyundai santa fe

The rear door problem is the lock actuator. The problem with locks keep activated when you close driver door. My uncle's Santa Fe has same problem and couldn't fix problem under any circumstances. I even rebuilt the entire lock system didn't help

In 2002 they discontinued the external trans filter. So your vehicle could have the external filter. If you look next to the trans dipstick tube, on top of the trans case you will see the filter or you will see just a spot where the filter use to go before they eliminated it. Yes, the filter does llok like a regular engine oil filter. If the trans does not have the external filter ontop then there is no service to the filter to be done, the only recommendation is to bring vehicle into a shop to have the fluid flushed. By the way, make SURE you use the correct Hyundai SP-III trans fluid (not dexron/mercon). This fluid is specific to the Hyundai and can not be purchased from auto parts stores, only the dealership. Failure to use SP-III will cause premature wear to the internal bands and clutches.

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything someone on fixya recommended it to me and I thank him even today They have full manuals and it's verrrrry cheap and mine I got free in offers 3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins there is one website more but i don't remember its name it was 2 years back bitman something link this Try these out brother

Sounds like your auto locking/alarm system is out of sync with the buttons on your key fob. You will need to reset it so the fob buttons match what they should do. You will need to go to the alarm system manufacturer for directions on how to do that.

thtaxs nicer

http://www.bbbind.com/tsb-wiring-diagrams-database-results/?type=WD&years=2004&make=3&makeDesc=Hyundai&model=26&modelDesc=Santa%20Fe&system=5&systemDesc=Engine&subsystem=80&subsystemDesc=Fuel%20Controls&docid=7903702

Who gonna fix dealer should know the best???

more likely is #15

What is v/c and what is wrong?

Could be a bad four-way switch.

What is the problem now?

PO705 this is transmission code do you have any problem?

What is the code? could be crankshaft sensor.

Any codes? look you have problem code will tell you which is bad.

I have an 03 Santa Fe as well and just had the exact thing happen to me. One day, it just wouldn't turn over at all and I had to have it towed to the dealer. They replaced the "crank shaft position sensor" and now the car is fine. I am not sure if this is your problem but it might be worthwhile asking someone to check it out.