Hyundai Elantra - Answered Questions & Fixed Issues

Use a good scan tool which should identify the failing sensor/circuit when the vehicle stalls,so you can do the correct repair.

Hyundai Elantra... | Answered 3 hours ago | 26 views

By pass clutch signal by appling +12vdc to A/C clutch directly - check for proper suction side pressure with A/C gauge connected to suction side of compressor - if pressure is low clutch will not be energized do to low pressure cutout switch. Add freon or 134A to bring up suction side pressure.

Hyundai Elantra... | Answered 11 hours ago | 22 views

Cannot bypass ignition switch and start vehicle because of built in factory anti-theft circuit. Need to re-program ignition key - check with locksmith. Starter can be energized by jumping +12VDC directly to starter Ign terminal but no ignition spark will occur due to anti-theft system. Vehicle motor will turn over but engine will not start and stay running.

2016 Hyundai... | Answered 11 hours ago | 21 views

Try this fuse (fuse box - inner panel) :


2005 Hyundai... | Answered Yesterday | 22 views

Is it possible that your blower motor is going out and drawing too many amps and burning out the control module? Or maybe a poor ground or bad connection?

2014 Hyundai... | Answered 3 days ago | 19 views

Sounds like the beginning of a bad 02 sensor. If your engine light is on that’s the issue. I could almost guarantee it. Any auto part store will read the ecu codes for free.

Hyundai Elantra... | Answered on May 15, 2019 | 18 views

I do not see a maf for your car. Many designs use only the map and tps to calculate airflow.

2015 Hyundai... | Answered on May 07, 2019 | 27 views

Run a compression test or cylinder leak down test on the engine. You have an oil control ring or a valve seal that is failing.

1997 Hyundai... | Answered on Mar 01, 2019 | 26 views

Is it a rapping noise from the engine?If so it may be covered under warranty for a new replacement engine block assembly.Many are defective.

2015 Hyundai... | Answered on Mar 01, 2019 | 44 views

Clean off leak as good as you can. You can buy a die to put in the oil, usually yellow. After driving for directed amount of time on bottle you put on the ultraviolet sunglasses that come with the kit and you can see where your leak is coming from. Might help to pin point it at least. Hope this helps

1997 Hyundai... | Answered on Mar 01, 2019 | 32 views

It could be, but you need to do some trouble shooting to determine the issue. Is there power to the switches? is there power to the clock spring? Is there continuity through the clock spring? Determining where the issue is will save $$.

2012 Hyundai... | Answered on Feb 28, 2019 | 81 views

You would have to ask a dealership. If Google doesn't know, then no one does and this code doesn't exist.

Hyundai Elantra... | Answered on Feb 24, 2019 | 27 views

Possible issue with the clutch pedal lock out switch. This switch will not let the engine start unless the clutch is full depressed.

Hyundai Elantra... | Answered on Feb 14, 2019 | 26 views

Most likely #1 fuel injector is dirty or defective causing a lean condition on # 1 cylinder.

2009 Hyundai... | Answered on Feb 05, 2019 | 27 views

Thanks Aquinas. It worked fine!

2000 Hyundai... | Answered on Feb 05, 2019 | 207 views

They should come on with lights or parking lights. It can be anything from bulbs to light switch and wiring that is the problem.

2005 Hyundai... | Answered on Jan 16, 2019 | 31 views

Not finding what you are looking for?

-3,958 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts


Level 3 Expert

84619 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides