Hyundai Elantra - Popular Questions, Answers, Tips & Manuals - Page 5


The head gasket is allowing compression gas into the water jacket. Did you have the head ground flat before installing it on the head gasket?. Was the old head gasket completely removed from the block? It doesn't take much if a speck of old gasket remains on the block.

2004 Hyundai... | 61 views | 0 helpful votes


The brake light switch could be stuck.

Hyundai Motor... | 14 views | 0 helpful votes


Which engine ?

2000 Hyundai... | 77 views | 0 helpful votes


remove battery neg cable for 15 minutes then retry radio buttons. it will some times help with that otherwise it is internal radio issue

Hyundai Elantra... | 432 views | 0 helpful votes


Remove the two screws holding the bracket to the back of the glove box and lower the bracket. Then remove the glove box and you can access the cabin air filter door

2001 Hyundai... | 79 views | 0 helpful votes


Try YouTube. Type disable car alarm or car alarm keeps going off. You'll find several videos of people fixing alarm malfunctions.
Good luck. Hope this helps.

2000 Hyundai... | 337 views | 0 helpful votes


yup take it to a shop that has a press

Hyundai Elantra... | 265 views | 0 helpful votes


Normally the bulb socket and wires powering the bulb are accessed from behind. The plastic socket may come out by twisting it to the left and then pulling it out (bayonet style socket). The bulb is most likely a small glass bulb with a flattened base that just pulls out. Take it to any car parts store to find a replacement - look for a style number on the bulb. Note the way the wires are folded up along the side of the bulb when you pull it out. You'll want to put the new bulb in with the wires folded up the side of the base the same way. If the bulb is an older style round metal based bulb, it is normally removed by pushing in, twisting to the left and then pulling it out (also bayonet style). Take it to the car parts store to find a matching replacement.

Hyundai Elantra... | 27 views | 0 helpful votes


1997 elantra My personal suggestion would be to go for these repair catalogs. I know this website reliable-store that i used to buy them from, and they sold online it was very good manual.

Hyundai Elantra... | 23 views | 1 helpful votes


Sounds like a faulty turn signal switch. If you checked all the fuses, and I would have even replaced them just to be sure. I had one years ago that looked good, but it was defective. If you need a new switch, check rocksuto.com
I find that they usually have the cheapest prices.

Hyundai Elantra... | 25 views | 0 helpful votes


indicates a faulty strut cartridge insert
take it to a suspension specialist for replacement
they come as pairs so have both sides done
labour time is around 2 hours max

Hyundai Elantra... | 36 views | 0 helpful votes


Sounds like the idle sensor needs replacing

Hyundai Elantra... | 23 views | 0 helpful votes


run the fault codes and check for problem heated oxygen sensors(HO2S) and blocked cat converters

Hyundai Elantra... | 84 views | 0 helpful votes


Check the tempreture sensor pluge and crank sensor .try to use air to dry them.
And check the fuse box too you have to dry it too

Hyundai Motor... | 61 views | 0 helpful votes


Ok, go to YouTube, and in the search box type: 2003 Elantra starter replace. It will show you a 11 minute video of a guy doing the actual job.
Good luck :)

Hyundai Elantra... | 192 views | 0 helpful votes


bad battery
bad ground
bad starter relay
dirty battery terminals

2000 Hyundai... | 33 views | 0 helpful votes


It's not likely the plugs. Please get a scan at your local parts store, write down the trouble codes, and post them here.

2000 Hyundai... | 69 views | 0 helpful votes


Sounds like a misfire (bad ignition coils)
You need to get it scanned for trouble codes.

2004 Hyundai... | 79 views | 0 helpful votes


Hi the trans range switch or some times called an inhibitor switch needs replaced and have the bands adjusted for the transmission which is an external bolt with jamb nuts near the range switch after that has been performed the battery cable removed for 10 minutes to reset all adaptive learn for transmission

1997 Hyundai... | 58 views | 0 helpful votes


Do you know what a wiring diagram is ? How to use a DMM - digital multi-meter to check B+ voltage to the alternator ? Instead of just trying to fix by replacing alternators multiple times ! Free wiring diagram's here http://www.bbbind.com/free_tsb.html Enter vehicle info. Year , make , model an engine size. Under system click engine. Then under subsystem click on charging . Click the search button ,then the blue link. Looking at the wiring diagram i see multiple connections at the alternator , they should all have B+ voltage . With volt meter do voltage drop testing. Sounds like you could have a high resistance problem when warm .
Voltage Drop Testing the Charging System
Does the charge indicator light on the instrument cluster light .

Hyundai Elantra... | 56 views | 0 helpful votes

Not finding what you are looking for?

-3,958 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...