Honda Cars & Trucks - Popular Questions, Answers, Tips & Manuals
1995 Honda TRX 300 No Spark while cranking starts when start button is released, also starts off the kick start
When you have a situation where a vehicle like your Honda TRX 300 starts only when you release the start button or when using the kick-start, it's often indicative of an issue with the ignition switch or wiring. Here's a step-by-step troubleshooting guide you can follow:
- Check the Ignition Switch: Sometimes, the ignition switch can malfunction, causing intermittent starting issues. Make sure it's functioning properly by checking for any loose connections or signs of damage.
- Inspect the Wiring Harness: Over time, the wiring harness can degrade, leading to electrical issues. Look for any frayed wires, loose connections, or damaged insulation. Pay close attention to the wiring around the ignition system.
- Test the Ignition Coil: The ignition coil generates the spark that ignites the fuel in the engine. Use a multimeter to test the resistance of the ignition coil. Refer to your vehicle's service manual for the specific resistance values. If the ignition coil is faulty, it may not provide a spark consistently.
- Check the Spark Plug: A faulty spark plug can also cause intermittent starting issues. Remove the spark plug and inspect it for any signs of fouling, such as carbon buildup or damage to the electrodes. Replace the spark plug if necessary.
- Inspect the Kill Switch: The kill switch is designed to shut off the engine by grounding the ignition system. If the kill switch is malfunctioning or stuck in the off position, it can prevent the engine from starting or cause intermittent starting issues.
- Test the Starter Relay: The starter relay sends power to the starter motor when you press the start button. Use a multimeter to test the continuity of the starter relay. If it's faulty, replace it with a new one.
- Check the Battery: A weak or faulty battery can cause starting issues. Test the battery voltage with a multimeter. It should read around 12 volts or higher. If the battery voltage is low, recharge or replace the battery.
- Inspect the Starter Motor: If the starter motor is not engaging properly or is worn out, it can cause starting issues. Check the starter motor for any signs of damage or wear. You may need to remove it for a closer inspection.
By systematically checking these components, you should be able to diagnose and fix the starting issue with your Honda TRX 300. If you're uncomfortable performing these checks yourself, it's always a good idea to consult a professional mechanic for assistance.
2005 Honda sedan. How to test my thermostat without taking it out of my car.
Is the vehicle overheating? You can use a infra red thermometer to check the temperature both sides of the thermostat housing. That is the only way to check without removing it. The temperature through all parts of the cooling system should be within a few degrees.
The proper way is to remove the thermostat and put it in a saucepan of cold water and bring it up to a simmer. You put a thermometer in the water and watch for the thermostat to open. The opening temperature is in the specs or stamped onto the thermostat itself.
..
1997 Honda Accord SE What would cause it to suddenly not want to start when cranking ?
Several factors could cause a 1997 Honda Accord SE to suddenly not start when cranking:
1. **Battery**: Check the battery terminals for corrosion and ensure they are tightly connected. A weak or dead battery could prevent the engine from starting.
2. **Fuel**: Verify that there is enough fuel in the tank. If the fuel pump is failing or there are issues with the fuel system, it could cause starting problems.
3. **Ignition System**: Faulty ignition components such as the spark plugs, ignition coil, or distributor cap could prevent the engine from starting.
4. **Starter Motor**: If the starter motor is failing or the connections are loose, it may not engage properly to start the engine.
5. **Engine Timing**: Issues with the timing belt or timing chain could affect the engine's ability to start.
6. **Engine Sensors**: Malfunctioning engine sensors such as the crankshaft position sensor or camshaft position sensor could disrupt the starting process.
7. **Electrical Issues**: Problems with the electrical system, such as a faulty ignition switch or wiring issues, could prevent the engine from starting.
If you're unable to diagnose the issue yourself, it's recommended to have a professional mechanic inspect your vehicle to determine the exact cause of the starting problem.
2014 honda odyssey 3.4 code p0360 won't start
P0360 is an issue with the ignition coils and the related systems. There is an issue with the Powertrain Control Module (PCM) not detecting a signal to one or more of the coils. The engine might not be getting the signal to fire the spark plugs and that is why it won't start. You will need to get a good mechanic or auto-electrician to look at this.
Not finding what you are looking for?