C1500 or K1500 ,2wd or 4wd/
THE TRANSMISSION MUST BE EXACTLY THE SAME OR PCM MUST BE REPROGRAMMED
4l80 IS CLASS SERIES OF BOX.
NOT EXACT, EVER. MANY VERSIONS ARE MADE OF THAT SERIES. FOR ALL GM VEH..
even special gear ratios and 4wd /2wd differences
only ford can answer that and to get any valid answer
the alien box 2500 transmission tag must be told to ford.
or go to a tranny shop ask them for a look up
tag or photo the tag in hand.
or get the RPO list for both trucks
see Mxx numbers for tranny.
the 2500 uses at least 6 versions. of box. tranny codes IDs. M30 or MT1 and 4 engines
you do know each engine opted day one the gear ratios can be different. right?
the shop manual on the box shows huge table of variant for series 4L80
the codes are called by GM model codes.
(sub codes those are)_
the OSHD I THINK IS THAT CODE.(random gm 4L60/80 codehere)
I say read your C1500 RPO list see if it is M30 box
and buy , that box and model code matched.
know this too, GM will not have PCM programming for boxed not sold day1 new that C1500/
but do ask them. vast transmission exist for just 1 series.
The fuse for the security system in a 1998 GMC Sierra is located in the fuse box under the dashboard on the driver's side. The exact location of the fuse may vary depending on the specific model and trim level of the vehicle. You can refer to the owner's manual for your GMC Sierra or consult a mechanic or automotive electrician for assistance in locating the specific fuse for your security system. It's important to note that tampering with the fuse box or electrical system of your vehicle can be dangerous and should be done with caution or by a professional.
Question edited for clarity. Did you know typing in CAPS is considered shouting, plus it is harder to read.
Question moved to model category.
The EGR valve is located in the engine compartment (underneath the hood). Most engines require exhaust gas recirculation to meet emissions standards.
The ignition module is what supplies the signal to fire the injectors. That would be my first thing to check, especially if it wasn't a quality part. Just because it's new, doesn't mean it's good...
what computer of many?
to get them all pull battery neg lug for 15min
make sure radio license codes are learn first.
he radio manual (glove box) tells how.
Question edited for clarity.
Question moved to model category.
3: 1988-95 5.0L, 5.7L and 7.4L Engines Firing Order: 1-8-4-3-6-5-7-2 Distributor Rotation: Clockwise.
I would start with a new battery once the cells in a battery go bad they won't hold charge so when you jump them and try to start them they aren't holding in voltage in the battery which doesn't allow the car to start. A starter pulls a lot of amp. If you don't replace the battery stalest try charging it on a low amp battery charger
If you think your car door is opening incorrectly, open your door and grab both side of the door by the door handle and try to lift it up and down. If you can move the door a lot without moving the car, you issue is most likely door hinge pins and bushings
It can be difficult to determine the source of an oil leak, especially if the valve cover has already been replaced. Here are some common causes of oil leaks in vehicles:
Engine gasket leaks: Engine gaskets can leak oil, causing oil to seep out onto the engine and surrounding components.
Engine oil seals: Engine oil seals can become worn or damaged, causing oil to leak from the engine.
Engine oil cooler: Engine oil coolers can develop leaks, causing oil to leak out of the engine and onto the manifold.
Engine oil pan: Engine oil pans can develop leaks, causing oil to leak out of the engine and onto the ground.
Engine oil filter: Engine oil filters can develop leaks, causing oil to leak out of the engine and onto the manifold.
If you are unable to locate the source of the oil leak, it is recommended to have a professional mechanic inspect the vehicle