Ford Taurus - Recent Questions, Troubleshooting & Support - Page 6

Refer to you tube !

go to your local Ford dealer.

2005 Ford Taurus maybe needind a recalibration of the ECM.For lack of power at highway speed,Misfire at load?low RPM also,The operation of a fuel pressure sensor is to limit voltage to the fuel pump when certain amount of fuel is not needed,and increase voltage when fuel is needed.If anything you need a recalibration of the ECM.

you have to step on the brake to get it out of park

pic 1
pic2
pic3

I would replace the AC compressor cycling switch it may be sticking have seen it a number of times. The switch is located in the receiver dryer on the passenger side of the engine compartment. See picture below.

If this isn't the problem the AC compressor relay may also cause this, flip a coin.

Did you try filling at a different service station. Your issue seems pretty rare, but other have reported it. https://www.google.com/search?q=ford+taurus+2002+won%27t+fill+gas ..

Look @ utube

Please check this link: https://www.google.com/search?q=2003%20ford%20taurus%20wiring%20diagram%20pdf

2000 Ford Taurus 3.0 liter V-6 VIN "2"




2000 Ford Taurus 3.0 liter V-6 DOHC VIN "S"




2000 Ford Taurus 3.0 liter V-6 VIN "U"




Hope helps (remember rated and comment this)

If you are sure there is no other fault , you may have get a locksmith to reprogram the ignition keys to the ignition switch .

It is inside the that box on top of radiator with large wire plug. it cannot be replaced by itself. You must replace the whole unit.

https://www.modifiedlife.com/2004-ford-taurus-car-radio-wiring-diagram/

The system to change from vent to defrost etc. it's all vacuum controlled. First thing I would do is look inside your engine compartment and look at all the black hoses close to the firewall. Check to see that they have no cracks, have come apart, this is also a good time to check your oil, and do a visual for anything that doesn't look tight or right. In Ford your temp is cable controlled but vents are all vacuum. Words case scenario you may have to take off that control panel to investigate further. One last thing if you can look under the dash tho make sure morning had been kicked loose. A good trick to use for an inspection like that is a mirror and flashlight. Let me know. Jim

remove belt make sure you have the routing diagram for the belt. Take old tensioner off install new one reinstall belt ,tensioner will need to have tension taken off with wrench take tension off install belt let the tensioner go easily and slowly.

I need factory stereo wiring for speakers for 2000 ford taurus ses

Confusing question Fuse Box Location The Smart Junction Box is located on the left underside of dash. The Relay Center Box is located on left front of engine compartment near ABS control module.Sep 12, 2018

2006 Ford Taurus Fuse Diagrams - Ricks Free Auto Repair ...

Seat Belt Sensor https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&hl=en-GB&sxsrf=ALeKk037_C7k634crP_8xYhwH9dW2pW6Sg%3A1612031004988&ei=HKQVYObvO73k5NoP3YGn0AQ&q=2006+ford+taurus+seat+belt+sensor Fuse Box diagram by model spec

Fuse Box Diagram Ford Taurus (2000-2007) - Fuse-Box.info

fuse-box.info > ford > ford-taurus-2000-2007-fuses-an...

Jump to 2006 - Here you will find fuse box diagrams of Ford Taurus 2000, 2001, 2002, 2003, 2004, 2005, 2006 and 2007, get information about the location ...

If you have to hit the motor to get it to spin, it is faulty.

hello, you should try clicking the batten its yellow? send the answer again if you don't have the batten

Diagrams here https://www.google.com/search?q=2001+Ford+Taurus+24+valve+doh+firing+order ..