Fiat X1/9 - Recent Questions, Troubleshooting & Support

Possibly a disconnected sensor.

1. Disconnect the battery from car terminals.
2. Remove the alternator drive serpentine belt.
2.1. The serpentine belt routing diagram for Fiat Doblo 1.9 without A/C (Air Conditioning)




2.2. The serpentine belt routing diagram for Fiat Doblo 1.9 with A/C (Air Conditioning)



3. Disconnect electrical connection wires of the alternator.
4. Remove the alternator fixation bolts.
5. Remove the alternator out from the engine.
6. Install all in reverse order of the alternator removal.

thats the manual you were looking for ! http://www.avtoitalia.ru/katalog/Haynes-Fiat_Uno_manual.pdf

I to have searched for a manual, but haynes don't do one, however Peter Russek manuals do cover the scudo, with everything covered except gearbox overhaul and body panels. Search on ebay, can get em for about 15 quid. hope that helps my friend.

Blend door may be stuck or heater core is clogged .

its not the ecm! then so it has to be one of the sensors you need to get the fault codes out of the new ecm using a code reader but clear all codes first from the new ecu then drive it and when the fault does it again recheck the fault codes that then gives you a clue

my fiat palio petrol 2001 modal vehile good running but 15km after running engine poor piukup what is the reason

check fuses first, if all fuses ok then u have bad cig lighter.

check all connectors, fuse and check smo hose and pipe for clogging(air&fuel lines)

You might need to clean the sensors due to collect Alot of dirt off the road the sensors. Are located behind the brake discs and rear drums u might have to clean them all and if that don\'t work get them reset.