Dodge Ram 1500 - Recent Questions, Troubleshooting & Support - Page 5
Where is the throttle position sensor at on a 2005
THIS ENGINE HAS ELECTRONIC THROTTLE CONTROL..THERE ARE 2 THROTTLE POSITION SENSORS LOCATED IN THE THROTTLE BODY,COMPLETE ASSEMBLY MUST BE REPLACED IF DEFECTIVE..IT ALSO HAS SENSORS IN THROTTLE PEDAL ASSEMBLY AS WELL..WHAT TROUBLE ARE YOU HAVING?
How do you remove the
1st jack and use jack stands to safely lift the truck.disconnect brake lines and cables, remove tires,unbolt universal rear end to driveshaft, unbolt center bolts from axle to leaf springs, pull the rear end out from the side-much easier with two people. reverse process to put the new one on. I assume when you say axle you mean entire rear end. If you need to remove one axle side just take off tire and brake then remove rear end punkin cover and pull shear pin to remove your ring gear and planetary gear-pull axle shaft.
2001 ram 1500 2wd 5.2l truck hesitaion on startup and pinging
it sounds like the intake manifold plenum pan gasket is leaking..open throttle plates and look for engine oil pooling inside intake manifold..if there is,you have to remove intake manifold..there is a pan/cover bolted to bottom of intake..gasket will look like it's out of place..you need to replace this gasket and bolts..you can get these from your local dodge dealer..you will also need new manifold gaskets..this is causing your oil consumption and spark knock issues..there is also a software update for the engine controller for spark knock..let me know what you find
2004 dodge ram 1500 5.7l headlights keep turning off
Looks like the multi function switch goes to the cluster where lighting commands are issued across the CAN to the TIPM.
What codes are stored?
If there are CAN bus failures then there's what to go after first. Otherwise it's likely a failing TIPM, but all the TIPM and instrument cluster power and grounds need to be checked.
Where is the driver side brake light fuse located
Under the Hood in the large black fuse box next to the battery. Check fuses 32 and 34. 32 is the Right side and 34 is the left side. Both are 10A.
**Note** ALWAYS replace fuses with one of the same Amp rating.
Not finding what you are looking for?