Cadillac Escalade - Recent Questions, Troubleshooting & Support
2000 Cadillac Escalade. The fuses for tail lights keep blowing, why?
Brett has the right answer. It is a dead short because of the reasons he mentions. Great work Brett. Also check behind the fuse box for rubbed or damaged wires.
Brett Duxbury Feb 19, 2022
Hi Jacquelyn Hafenscher, we want to help you with your question, but we need more information from you. I don't know your car model but check the tail light lens is not full of water
check the wires - what colours are the tail lights .
Check the wiring loom going through the boot to the passenger compartment under back seat and under the carpet for exposed wires.
Has the car had any crash in the back ?
the wires going to other side tail light may have been crushed inside the back car panel
2007 6.2l. How can I retrieve a piece of the camshaft position sensor?
no car told at all just and engine flying in space?
a GM engine? LS3/
gee plastic material , steel washer. screws, nuts, bolts, what?
or just gasket material.
anythng metal is super bad dropped inside any engine
but if it falls to the oil pan only it is probably ok.
the pick up screen can not suck it in
The LS is VVT cams, so dropping junk there and hear chain and on those many parts there is asking for trouble.
the video on LS chain access is super long job,. so now you know it is easy to dismantle
1/9/2023 2:02:41 PM •
Cadillac...
•
Answered
on Jan 09, 2023
Flashing red light above rear window
The red lights represent the actual rear lights of the car's brake and signal indicator lights, also would alert you when bulbs were not functioning properly.
Where do you find the
Hi,
These model Escalades are not fitted with a factory cabin filter.
Hope this helps
2006. Why does it run for 5 minutes, then stops and will not restart for 20 minutes?
Check temperature rise when engine is running in that 5 minutes.Check the coolant level. Bleed the air out if necessary. Some cars have an overheat cut off switch that may turn on when coolant is too low that none of it touches the tip of this switch. how many psi is the fuel pressure?
If it uses MAF instead of MAP, check if the hose from air cleaner to MAF has no leaks.
Not finding what you are looking for?