Audi A8 - Recent Questions, Troubleshooting & Support - Page 7
2004 audi a8 problems
XENON LIGHTS I MUST GUESS??U NEED TO HAVE THE CAR TESTED FOR DTCS!!LET ME KNOW HOW U DID !!!
4/11/2014 4:45:25 PM •
2004 Audi A8
•
Answered
on Apr 11, 2014
AC blowing warm air after restart in my S8
LET YOU TECHNICIAN MEASURE THE GAP ON COMPRESSOR CLUTCH.IS COMMON IF THE GAP IS TO BIG COMPRESSOR ENGAGE LATE.AFTER 2-3min.
LOCATE THE SENSOR FOR CABIN TEMPERATURE AND MAKE SURE IS NOT DUSTY . LET THE DEALER PLUG THE SCANNER AND READ THE LIVE DATA BEFORE START THE CAR.BAD OR DISCONNECTED SENSOR WILL READ -40*F. SELECT LIVE DATA AND WILL SEE THE SIGNAL FRO THE BODY CONTROL MODULE TO A/C RELAY(ON / OFF)
ENGINE DATA IS IMPORTANT TO. A/C CUT OFF ON OVERLOAD FROM ENGINE,POWER STEERING,ETC
.
3/29/2014 3:46:55 AM •
2009 Audi A8
•
Answered
on Mar 29, 2014
Audi codes
P1874 IS ONE MOUNT OF THA CARS ENGINE THE RIGHT ONE IF U STAND IN FRONT OF YHE CAR.THE OTHER ONE I CAN NOT REMEMBER!!
3/26/2014 5:31:44 PM •
2004 Audi A8
•
Answered
on Mar 26, 2014
Door side panel
SEND ME VIN TO SEND U INFO AND WHAT PANEL U WANT TO TAKE OUT!!
3/26/2014 5:28:22 PM •
2008 Audi A8
•
Answered
on Mar 26, 2014
Low coolant light keeps coming on but coolant looks full
look close at your expansion tank. you will find marks
max____
~~~~~~~~~~~~~~~~
min_____
after you drive for 5-10 min.the coolant expend and rise the level in the tank
fill the coolant to
max on cold engine
DON'T MIX COOLANT
USE ONLY FACTORY RECOMMEND
PENTOFROST SF (without silicates)
(Formerly LIFETIME ANTIFREEZE G12)
Size: 1.5 liters (1.59 quarts), Part# 8114107
Color: Pink & Clear
CLICK HERE FOR PENTOFROST SF SPEC SHEET
- Audi (after 06/1996 up to 2005); Spec. TL 744 F
3/24/2014 4:09:18 AM •
2005 Audi A8
•
Answered
on Mar 24, 2014
Car stalls out when stopped code reads for vaccume leak or maf sensor
After a while, the vacuum hoses in the Audi get VERY brittle, specially the ones in the back of the engine and one in the front that goes across the engine.
I had this same problem, and discovered while cleaning the EMF sensor, that the hoses practically disintegrate just by me touching them.
Feel those hoses and see how they are. If they are very soft and mushy, they will need to be replaced.
--Jorge.
3/18/2014 9:23:16 PM •
1998 Audi A8
•
Answered
on Mar 18, 2014
Front strut replacement instructions ?
jack up both wheels, undo the bolts to the hub both. on each side. leave the bolts in but remove the nuts. at the top open the bonnet and a spanner and an alan key will be needed to remove the top nut. wen this is out the top part metal and rubber that is under the nut. then remove the bolts on the bottom and it should drop down then pull off the hub. they now removed. soak every nut and bolt before removing them it may help you remove the bolts and nuts better. if any problems removing the hub end bolts use a hammer and a bit of wood put wood on the bolt and hit with the hammer on the wood not the bolt.
Not finding what you are looking for?
