Acura Cars & Trucks - Page 2 - Recent Questions, Troubleshooting & Support
Can I drive my 2001 Acura CL with the CD changer out?
Sure you can drive it. Only problem is the radio may have a security code if you pull the fuze you'll need the code...it should come w/ the owners manual....
if not then you gotta take out the deck and there should be a serial number behind the deck which will tell you the code for the deck.
Or the dealer can help with the vin and a ID that you own the car.
Best to you.
2003 Acura TL headlight electrical issue
You have done well so far, but what if both relays have failed or one is working and the other is stuck closed with burned contacts?
For a hundred dollars, you could get it diagnosed and fixed professionally by someone with the equipment and the ability to access and understand wiring diagrams. Relays and switches can be tested very easily. You have the added problem that the BCM is involved in lighting.
https://www.google.com/search?q=auto+electrician+near+me
..
2002 acura 3.2 tl radio code errors
You will have to go to dealer to have unlocked. The vehicle has built in theft lock system in radio. Most of them have code stored in radio that needs to be pulled before removing battery.
2002 Acura RSX running too rich.
How do you no it is running too rich? Your post is very lacking in details. Is the Check Engine Light on? It should be. Did you connect a professional grade Scan Tool and check for Diagnostic Trouble Codes? The electronics provide the clues.
For an RSX of they age it will have been raced and thrashed.
White Smoke is steam.
Blue Smoke is oil.
Black Smoke is too rich.
..
My 2005 Acura MDX CRANKS but does start what could it. Be
More information please. What exactly do you mean by "smoked some"? How heavy was the smoke, was it thicker and heavier than normal? Did it have colour to it like a dense white or a blue tint? This information gives clues to the problem.
The engine spinning but not starting is commonly a 'No spark' issue but if you can get it to run some of the time it could be a faulty sensor. Do you have any warning lights on the dash? It could be worth you getting it scanned with an OBD2 scanner to look for trouble codes. These give clues to any faulty sensors. If you have to pay for this service ask at 4 or 5 places as prices can be VERY different.
Why do you need access to the fuses under the stereo? These are not normally a common set of fuses that cause issues. The fuse panels most commonly used in an MDX are under the hood, left side trim panel (nearest the door hinge) in the driver's footwell and in the left side trim panel in the truck.
What size wrench do I need to get thermostat off 97 Acura 2.0
Hi Carma archer, USA CAR?
NO MODEL ACURA TOLD
CL, INTEGRA, NSX, RL, SLX AND TL ???
WE CAN NOT GUESS CARS.
WORST THE 6 ,MODELS IN USA ARE NOT 2.0L EVER.
2.2 lITER YES. 4 CYLINDERS.
IMO if you need to ask that, then you shouldn't try.
the bolts on the the STAT MAY BE
M6 OR M8 HEXHEAD.
TORX OR
ALLEN HEX INTERNAL.KEY TYPE.
ONLY LOOKING FIRST WORKS .
A BUCKET TO CATCH AF50% ANTIFREEZE DRAINED
HOSE CLAM TOOL.
SOCKET DRIVERS FOR THE 3 KINDS OF BOLT
AND FRESH AF50% AS 26 YEAR OLD IS NO GOOD
AND OLD HOSES MAY/WILL BE BAD.
THE VIN NUMBER TELLS WHAT CAR IT IS
THE VIN#8 DIGIT THE ENGINE
I'D HAVE SPARE NEW HOSE FOR THE FIRST ONE REMOVED TO THE STAT, THAT OLD
HERE IS 97 MODEL CL
COMING OFF
12/13MM HEADS SEEMS (HEX)
THE BOLTS ARE METRIC.
ALL SHOPS HAVE METRIC TOOLS, FOR SURE 12 TO 15MM ON ANY CAR FROM JAPAN.
2005 Acura TL. How to replace freeze out plug in it please.
there is none;
how to reach it, to remove it and or put them back in?
there are no core plugs in the 3.5L head
the block. has... NONE so why ask for it?
3.5 L
J35A8 (286 hp)
V6 (Type-S only)\\
none
but has screw plug for block heater, no freeze or core plugs here.
so you are confused or listening to internet geeks?
you saw leak to the ground sure.
but forgot to find the source and is not a freeze plug
there is NONE THERE>!
none
see all sides of it here, none;.
https://www.ebay.com/itm/165192135142
Acura tl 2011 it clicks on and off while driving and wont accelerate power steering signal came on no more steering and airbag sign came on completely shut down on me while driving
NEEDS SERVICE FOR SURE THOSE 2.
OR
battery cables tight and clean, jumper cable start it if starter is dead?
CHECK ALL FUSES, CAB/BAY
SCAN THE pCM OBD2 PORT FOR DTC ERRORS, AND SRS TOO
MAY BE THE BATTERY (UNDER HOOD)_ IS WEAK OR A FAILING ALTERNATOR.
'COMPLETELY SHUT DOWN MEANS ENGINE STALLED?
WELL IF THE BATTERY DIES, THE EFI DIES AND IF IT DIES ENGINE STALLS AND MOST TIMES WILL NOT CRANK UP AGAIN.
SURELY THE BATTERY IS NOT 12 YEARS OLD ,NO WAY DO ANY LAST THAT LONG, 10 MAX SEEN BY ME. 5 DECADES .
if will not crank now, jumper cable start it. or take the battery to a shop and get it charged and load tested.
if battery is new'ish clean the lugs and make them tight.
IS THE STARTER DEAD (KEYED TO ,START,CRANK)?????
TELL MORE FACTS, END TO END,
IF IT ALMOST STALLS AGAIN CAN YOU PREVENT THE STALL WITH FAST ACTING RIGHT FOOT?
these are just some ideas based on incomplete inputs
I can not see all the acts end to end.
for sure any restart actions.
I do suspect low battery due to 3 majors in the car failing,
EFI, SRS BAGS AND STEERING.
A DC POWER LOSS.
1998 Acura Integra. P0301 misfire.
If you have already checked the spark plugs, plug wires, fuel injectors, and distributor and are still experiencing a misfire in cylinder 1 and 2, here are a few more things you can check:
- Compression: Check the compression in cylinder 1 and 2 using a compression tester. Low compression could cause a misfire in one or both cylinders.
- Vacuum Leak: Check for a vacuum leak by inspecting all hoses and fittings for cracks, damage, or looseness. You can also use a smoke machine or propane torch to locate any leaks.
- Ignition Coil: Check the ignition coil to ensure it is functioning properly. You can do this by swapping the coils from cylinder 1 and 2 with the coils from another cylinder and see if the misfire follows the swapped coil.
- Fuel Pressure: Check the fuel pressure to ensure it is within the manufacturer's specifications. Low fuel pressure can cause misfires.
- EGR Valve: Check the EGR valve to ensure it is functioning properly. A malfunctioning EGR valve can cause misfires.
- PCM/ECU: If all other components have been checked and are functioning properly, it is possible that the PCM/ECU (Powertrain Control Module/Engine Control Unit) may be faulty and may need to be replaced.
It is recommended to perform these checks in a methodical manner to narrow down the cause of the misfire. If you are not comfortable performing these checks yourself, it is recommended that you seek the assistance of a professional technician.
Steps in exchanging the thermostat on a 2003 Acura RL
no engine told, and is a 100% engine question
no country told making the engine guess 10x more easy or no VIN and 8th digit is engine code.
3.5L RL? V6 (seen in USA?)
the steps are the same on all cars but 1,
the gain access step.
also 20 year old coolant is no good at all
- drain all coolant
- gain access to STAT
Disconnect any sensors or switches that may interfere with the removal of the thermostat from the housing.
- remove STAT housing hose.
- remove STAT housing, (unbolts)
- remove STAT
- put in new STAT , not a backwards and bleed hole must be upward side. with new SEAL
- bolt it down. Hose back on.
- Rad cap off
- fill up coolant 50%AF (i uses Prestone ALL CAR)
- burp out all air
- cap back
- drain out side tank and refill 1/2 way with 50%$AF
done
SM
or read the manual your self (service man)
https://eautorepair.net/Marketing/Default.asp
Not finding what you are looking for?