ATVs - Page 4 - Answered Questions & Fixed Issues

0helpful
1answer

Tao tao 110cc automatic will not move with weight on it, but if you lift up the rear end it will move. can you help

First of all are your rpm up if so its the clutch needs adjustment last the oneway bearing is bad
6/5/2023 2:38:15 AM • ATVs • Answered on Jun 05, 2023 • 529 views
0helpful
1answer

HS400atv, will not power up. Battery is definitely charged. Ignition switch replaced once, week later had the same issue. Is there a module i should be looking for instead?

If your HS400ATV is not powering up even with a fully charged battery and you've already replaced the ignition switch, there may indeed be another module or component that could be causing the issue. Here are a few possibilities to consider: 1. Main Fuse: Check the main fuse for the ATV. It is typically located near the battery or within the fuse box. Ensure that the fuse is not blown and is making proper contact. A blown main fuse can prevent power from reaching the ignition switch and other electrical components. 2. Starter Solenoid: The starter solenoid is responsible for engaging the starter motor when you turn the ignition key. If the solenoid is faulty or not functioning correctly, it can prevent the ATV from powering up. Inspect the solenoid for any signs of damage or loose connections. Consider testing the solenoid or replacing it if necessary. 3. Kill Switch/Safety Interlock: Check if there is a kill switch or safety interlock feature on your ATV. These safety mechanisms are designed to prevent the ATV from starting under certain conditions, such as when the brakes are not engaged or if the ATV is not in neutral. Make sure these switches are in the correct position and functioning properly. 4. Wiring and Connectors: Inspect the wiring harness and connectors for any loose, damaged, or corroded connections. Pay close attention to the connections between the battery, ignition switch, and any other modules or components. Clean and tighten any loose connections, and repair or replace any damaged wiring or connectors. 5. Electronic Control Module (ECM): The ECM or other control modules could be a potential source of the issue. These modules control various electrical functions in the ATV. However, diagnosing and testing these modules often requires specialized tools and knowledge. It may be best to consult a professional ATV mechanic or an authorized dealer who can properly diagnose and test the modules if needed. If you've checked these possibilities and the issue still persists, it is recommended to seek professional assistance. They will have the expertise and equipment necessary to diagnose and resolve electrical issues specific to your HS400ATV.
5/20/2023 5:22:45 PM • ATVs • Answered on May 20, 2023 • 285 views
0helpful
1answer

Looking for Honda TRX250X - Sport ATV Engine?

Question edited for clarity. Question moved to model category. Here is the engine. https://www.google.com/search?q=honda+trx+250+engine+for+sale Bayou wiring harness https://www.google.com/search?q=Kawasaki+Bayou+300+wiring+harness+replacement ..
5/8/2023 11:47:02 PM • Honda 2005 TRX... • Answered on May 08, 2023 • 44 views
0helpful
2answers
0helpful
1answer
0helpful
1answer

Cv joint 0501123A

4/21/2023 6:36:41 AM • Bobcat 2012 3450... • Answered on Apr 21, 2023 • 125 views
0helpful
1answer

My Arctic cat 08M8 is very hard to pull start any solutions

4/21/2023 6:36:04 AM • Arctic Cat 2009... • Answered on Apr 21, 2023 • 545 views
0helpful
1answer

2004 Yamaha Kodiak 400 ATV. It does not start. The starter clicks like a car battery does when battery is drained. A new battery lasted only a month or so.

Get a battery tender to put on the battery when you aren't using it to keep it fully charged. Check battery connections and grounds. Check the starter relay plus the starter and solenoid. Call an auto electrician. The videos may help diagnosis.
4/21/2023 3:37:15 AM • Yamaha 2004... • Answered on Apr 21, 2023 • 120 views
0helpful
1answer

2013 Arctic Cat Prowler XTZ 1000. User Manual for it please?

Question edited for clarity add maker and turn question around.

Arctic Cat 2013 Prowler XT Service Manual

ManualsLib https://www.manualslib.com > ... > 2013 Prowler XT View and Download Arctic Cat 2013 Prowler XT service manual online. 2013 Prowler XT utility vehicle pdf manual download. Also for: 2013 prowler xtx, ...

Arctic Cat 2013 Prowler 1000 XTZ Service Manual

Service Manual Warehouse https://servicemanualwarehouse.com > Shop All This manual has everything you need to do repairs, service, and maintenance. Step-by-step instructions and exploded views are included to make your repairs ... $18.03 · ‎In stock
4/18/2023 3:59:28 AM • ATVs • Answered on Apr 18, 2023 • 49 views
0helpful
1answer

My 2003 arctic cat z570 has two pause lines running from motor can it be hooked up to a fuel pump that only has a spot for one pause line

Greetings, I read your question and I think heavy-equipmentmanual.com can help you in this. Here's the site link - https://www.heavy-equipmentmanual.com/
4/16/2023 9:14:29 PM • Arctic Cat 2004... • Answered on Apr 16, 2023 • 171 views
0helpful
1answer

How to check stater on 2001 artic cat Pantera 580 efi

You just go to the link I attached I'm sure you will get the solution of your problem https://heavy-equipmentmanual.com/
4/16/2023 9:14:15 PM • Arctic Cat 2006... • Answered on Apr 16, 2023 • 168 views
0helpful
1answer

I have a 98 Suzuki quad runner 500. 4x4 and put a snorkel on it but can't find all thee vent lines where are they please help

Greetings, I read your question and I think heavy-equipmentmanual.com can help you in this. Here's the site link - https://www.heavy-equipmentmanual.com/
4/10/2023 9:22:38 PM • Suzuki 2005... • Answered on Apr 10, 2023 • 151 views
0helpful
1answer

Honda Rancher 350 4x4 ES runs fine but won't go when shifted into gear?

See if the videos help. It has an electrical shifter.
4/2/2023 5:31:06 PM • ATVs • Answered on Apr 02, 2023 • 75 views
0helpful
1answer

How to remove starter on 2007 660 rhino

3/28/2023 7:51:16 AM • ATVs • Answered on Mar 28, 2023 • 183 views
0helpful
1answer

Wiring diagram on a Subaru 265cc Bulldog BD300 6 wires I can't find any diagram to match the one I have on mine?

it is an offroad ATV vehicle. and the maker of it has the only service manual contact them directly? we are them or sell parts or books. the users guide is here and contacts there at end are real no schematic here, parts list yes. https://americanlandmaster.com/pdfs/UTV/IPLs/2wd/265cc-CW265-TW265-BD300.pdf or learn to find shorts like pro. box of fuses. unplug all or 1 by 1 all connected devices to the harness if one device ends fuse blown, bingo. it is a shorted out device if at the end of all this work , and it still blows fuse then the harness is shorted, and just inspecting every inch of the harness finds that. short. (see actual damage to it you will) guess this 7625 DiSalle Boulevard Fort Wayne IN 46825 62194 Commercial Street Roseland, LA 70456 Toll Free 800-643-7332 Fax 800-399-1399 they took their web page off line (oops end of suport/? www.amsportworks.com best is buy the service manual the day bought it new and then have it on hand when they die.(the atv and or them)( GOOD LUCK, I did find an echo of the old manual 2008? to 2014? https://www.manualslib.com/manual/846214/American-Sportworks-Landmaster.html?page=36#manual
3/27/2023 1:12:18 PM • ATVs • Answered on Mar 27, 2023 • 156 views
0helpful
1answer

I have a 2010 Arctic Cat 550 H1 EFI and it stalls sometimes but always restarts. The fuel pump and regulator were both replaced with no effect. You can be running along and it just dies.

https://www.google.com/search?q=2010+Arctic+Cat+550+H1+EFI+stalls+sometimes Based on the information provided, there could be several possible reasons for your Arctic Cat 550 H1 EFI to stall. Here are a few potential causes to consider:
  1. Clogged Fuel Filter: A clogged fuel filter can cause a lack of fuel flow to the engine, leading to stalling. Even though the fuel pump and regulator were replaced, it's possible that the fuel filter may still be clogged or dirty. Consider replacing the fuel filter as a troubleshooting step.
  2. Faulty Ignition System: If the ignition system is faulty, it can cause the engine to stall. This could be due to a number of reasons, such as a failing ignition coil or spark plug. You may want to have the ignition system checked by a mechanic.
  3. Air Intake Issues: Problems with the air intake can also cause stalling. A clogged air filter, for example, can restrict airflow to the engine and cause stalling. Make sure to check the air filter and clean or replace it if necessary.
  4. Electrical Issues: Electrical problems, such as a faulty sensor or loose connection, can also cause stalling. You may want to have the electrical system checked by a mechanic.
  5. Fuel Injectors: The fuel injectors may not be working properly, which can cause stalling. Have a mechanic check the fuel injectors to ensure they are functioning correctly.
3/25/2023 11:46:22 PM • ATVs • Answered on Mar 25, 2023 • 129 views
0helpful
1answer
0helpful
2answers

How to adjust a clutch on Kawaski 4wheeler Bayou kif300f 4wd

Greetings, I read your question and I think heavy-equipmentmanual.com can help you in this. Here's the site link - https://www.heavy-equipmentmanual.com/
3/19/2023 10:47:56 PM • kawasaki 2004... • Answered on Mar 19, 2023 • 1,522 views
Not finding what you are looking for?
ATVs Logo

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

29494 Answers

Renee Knafel-Bullock

Level 3 Expert

404 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66855 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...