Comment ajuster le timmage des valves sur un vtt kawasaki bayou 300 1986

We only speak English on this North American website!! Also FULL 'year make model' please.

Charging problem on a 2012 kvf 750

Videos

https://www.google.com/search?q=kvf+750+charging+problems

..

..

what year ? 1999 should be 15 to 20 mm intake on exh 18 to 23 mm i think depending on year. they run tight. adj at tdc on comp stroke with valves open far as they can. have to rotate eng for each valve to open fully and independently one opens and other closes at same time. should be very quiet if adj correctly.adj the closed valve only when fully closed

I suggest you check the exhaust isn't partially blocked and then if OK ensure the cam timing, valve clearances, etc. is correct.

good luck..
Kawasaki bayou 300 service manual free download vbou

timing may have jumped and bent the intake valve causing it to blow back into the carb on the compression stroke.

clean carburettor there is a clot in it or on fuel line and petrol reserve on off valve.change fuel filter and try it.

Chapperalmotorsports.com has free diagrams for everything outdoors i use their service often they will help you with the instructions too. Hope this is useful for you i have always had great luck with them they go out of their way to answer any question &i their prices on parts are great

T is usually the mark on the flywheel and there's usually a mark on the cam sprocket and head to line up. you can google up a service manual too most likely.

valves make a ticking noise, knocking comes from your bottom end (crank bearings etc). try a thicker oil and see if it changes anything

if its a light ticking noise it may be your valve train, if its a heavier knock it would most likely be your bottom end, crank/bearings etc...