SOURCE: gear shaft
If you are trying to change the boot over the U joint at the swing arm, you don't need to remove any shaft to do that. You do however have to remove the swing arm.
SOURCE: 1987 yamaha xt600 teneree slight vibration in 5th
The balance shaft isnt likely to jump a tooth, unless someone has installed it incorrectly. And if this was the case there would be problems in all gears
Youve probably done this but check the chain and sprockets are in good condition, and adjusted correctly.
SOURCE: Hi, I
From memory I believe there are a couple of dots on the balance shaft drive gears, the dots line up together
SOURCE: i have a 1986 yamaha
The timeing markings should be on the flywheel, F = fire T = top dead centre, however with the piston at the uppermost point, this is known as tdc, and the camshaft should be fitted with the cam lobes facing downwards, thus the valves closed in this position, on e assembled, move engine slowly with spanner untill 1complete cycle with no obstructions, if the engine meets any obstructions stop and recheck timeing and correct, if ness
727 views
Usually answered in minutes!
×