Question about ATVs

1 Answer

How to drain radiator on Polaris ranger - ATVs

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Contributor
  • 10 Answers

Take the hose off at the water pump at the rear bottom right of engine

Posted on Jul 13, 2019

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to Find the Temperature sensors on a 2012 Polaris Ranger


It's not about the sensor. Overheating of the engine and the formation of gas bubbles during operation of the engine in the expansion tank must be replaced with a gasket of the cylinder block

Nov 14, 2017 | Polaris ATV

1 Answer

Where to find the serial number on polaris ranger


hi.
this is all i can find on the internet about it.
Where to find serial number on Polaris Ranger? Whenever corresponding about a Polaris RANGER utility vehicle, be sure to refer to the vehicle identification number (VIN) and the engine model number and serial number. The VIN can be found stamped on the lower frame rail on the front LH side of the vehicle (see Figure 1-1).

2011-2012 RANGER 800 XP / HD / CREW / 6x6 Chapter 1 - Asap911

asap911.com/wp-content/uploads/2012/.../2012-Polaris-Service-Manual-Chapter_01.pdf Search for: Where to find serial number on Polaris Ranger?.

how to find vin number on polaris ranger Google Search

Oct 31, 2017 | ATVs

1 Answer

Will Polaris Ranger start with a bad regulator?


Yes, it will start but it has a tendency to drain the battery. I had the same issue with mine and the dealership couldn't find the problem. I had a buddy verify the drain via electronic troubleshooter. I replaced the regulator and haven't had any problems since then.

Feb 22, 2017 | Polaris ATV

1 Answer

Where is the drain plug for antifreeze on 1995 425 4x4 polaris magnum


There is no drain plug for the coolant, you need to remove the lower radiator hose at the radiator to drain the coolant. Make sure you purge the air out of the system after the change.

Oct 27, 2016 | ATVs

1 Answer

Owners manual for Polaris ranger 2/4 model# A04RB42AA


www.polaris.com/en-ca/rider-support/owners-manual

Hope this helps

Sep 26, 2016 | Polaris 2012 Ranger 500 EFI

1 Answer

How to fix injector yourself


look below for workshop/repair manuals

http://www.ebay.com/sch/i.html?_odkw=polaris+ranger+800+service+manual&_osacat=0&_from=R40&_trksid=p2045573.m570.l1313.TR0.TRC0.H0.Xpolaris+ranger+800+service+manual+2014.TRS0&_nkw=polaris+ranger+800+service+manual+2014&_sacat=0

May 31, 2015 | Polaris 2014 Ranger Midsize 800

1 Answer

Have a 2011 polaris 6x6 800 that overheats every time I use it. The coolant will come out the over flow.


The most common causes of a water cooled engine overheating are (1) poor circulation of cooling fluid (bad water pump or stopped up radiator); or (2) inadequate air flow cooling (bad cooling fan); or (3) compression gases entering the cooling system (leaking head gasket or cracked block or head). The first check is to see if air is in the cooling fluid (small bubbles appearing in top of radiator or coolant reserve tank). If so, then #3 is the problem. The second check is to see if the cooling fan (s) is running properly (can feel air flow on output side?). If not check wiring and/or replace fan (#2). The last step is to drain the radiator and engine (turn over engine to allow water pump to empty the block). If additional cooling fluid does not drain out the radiator drain port, the water pump is defective. If the water pump does empty the block, then flush the system with a good flushing agent. Follow instructions on flushing agent bottle. Drain out the flushing agent and re-fill radiator and block with clear water. Run engine as per instructions on flush agent bottle. Drain system again and re-fill with antifreeze (50%) and water (50%). If vehicle is located in a very cold climate, then increase the antifreeze % up to 75% (25% water). Remember, not only does antifreeze help to keep water from freezing, but it also helps to increase cooling ability.

Feb 06, 2015 | Polaris 2011 Ranger 800 6x6

1 Answer

Is there cooler thermostats and fan stats avalilble for my 2014 polaris ranger


Yes there should be but check radiator for blockage if it is running to hot.

Aug 26, 2014 | Polaris 2014 Ranger Midsize 800

1 Answer

How to change oil


its on the bottom of the crankcase, You will see an allen wrench hole in the plug , through the skid plate here is the diagram for you http://purepolarisoil.com/pdf/RGR%20800%20Oil%20Change.pdf
hope this helps

Jun 12, 2013 | Polaris 2007 Ranger 6x6 EFI

Not finding what you are looking for?
ATVs Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

22423 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

 Scott Tx
Scott Tx

Level 2 Expert

604 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...