What I have to do to replace key for ignition in 2006 Kawasaki atv

https://www.kawasaki.com/Accessories/Item/KAF400JHF/270050625

Check out this Kawasaki Universal Ignition Switch

9 Steps to Removing Motorcycle Ignition Switch DoItYourself com

try them, worst case it doesnt start.

Check ignition switch. Should have power on red wire at all times. If power there check power out of switch.

Check fuse link under the seat. Look for the main 30 amp fuse. Also, could have shorted wire in the key housing where the key goes into the ignition. Put ohm meter on and check for continuity. this will tell if there is a short in the wiring. Hope this narrows it down for you.

battery good ? if so check master fuse...

If you need further help, reach me via phone at https://www.6ya.com/expert/allen_b068623c5003aa4b

On the right hand side of the ATV just under the gear leaver, you will find a grey and black multiplugs, you will need to swap them. Please see the link below. KAWASAKI 360 PRAIRIE BELT RESET

Primary should be very low, about 1-2 ohms. Secondary would be high-on the order of 7,500 -10,000 ohms. Check with Kawasaki for specific values-what they specify.

Kawasaki mule 610 new battery but little to no power to solenoid. Fully charged starter makes rapid clicking noise. When attacked to battery jump starter it will start. Mule was running excellent for 2 weeks with new battery. I was told by kawasaki technician it was ignition. Nope thoroughly skimmed inspected wires and see nothing wrong. Technician told me different second time, it's now the starter replaced starter ($450) and still no results I'm at a loss

cdi...ignition coil and all switches, run stop switch contacts may be worn, last resort..cut and tie together those two wires on switch, bet thats the prob