Find the drain plug on the 2011 4010 kawaski mule I have a leak can't find drain plug to check it ouy

You must have a big leak on the intake system. look for a vacuum hose that has been disconnected or cracked. Some times you can find it by spraying wd-40 around the intake and if the idle changes that is where the leak is.

Look it up on you tube they have alot of how too S for free. Good luck

Open fill cap and oil level should be full.

Hey Keith, get a manual.. its easier than trying to "diagnose" on here.. Sorry..good luck.. kawasaki mule 1000 450b1 repair manual Google Search

Kawasaki MULE 610 44 Service Manual

Carrie The VIN # can be found on the left front frame rail behind the wheel according to the link below.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

Vin Finder Kawasaki Protection Plus

There's a drain screw on the bowl of the carburetor - either run the gas out - or turn the valve to off and drain the gas in the carburetor. I also take the spark plug out and spray on top of the cylinder and all around - anything metal. GETSOME is a product out of Florida that actually works. Disconnect the battery and hook the battery up to a 2amp tender/not charger - you'll need the battery tender that keeps the voltage correct but doesn't over charge - reverse when the seasons change and you should be good to go -

Kawasaki Mule Update - YouTube

? 2:16
www.youtube.com/watch?v=Fw_jeQUU6Hw
Jan 25, 2013 - Uploaded by Penguinboy1995
solenoid is reading battery voltage and the constant hot, it is not sending the 12 volts from the switch to the ...

Air leak .dirty air filter.,.fouled plug.,.bad gas.,.dirty carb?fuel injection? Bad fuel filter ,fuel pump test fuel pump that's the general stuff.go from there

Hey Dennis, there is no way to tell what part number(s) you need.. this is not a complicated repair, but does take some knowledge.. if you are not very good, mechanic wise, I would find a qualified professional to help with it...it has to be RIGHT,, or it will break again..