How to remove rear brake rotor on 660 yamaha rhino
SOURCE: need help on repair manuel on yamaha rhino 660 top end
Go to bike bandit.com , it will give you a picture diagram of the comple engine, and transmission.
SOURCE: Trying to remove and replace rear brake rotors
First, make sure your parking brake is off.
Remove the rear caliper and then the brake pad housing. In the center hub of the rotor the parking brake shoes are located. The may need to be loosen first. There is a hole between 2 of the studs you need to align at the bottom. Look in the hole with a flashlight and find the star wheel. Use a screw driver to turn the wheel up a few turns to loosen the parking brake shoes from the rotor hub.
After that there are 2 threaded holes in the rotor near the studs you put two 8mm bolts in and slowly tighten each and it will pull the rotor off the hub. They rust up pretty bad so use penetrating oil on them.
SOURCE: Rear brake rotor removal
have to release the e break on the inside of rotor think this has an extra brk pad
SOURCE: HOW TO STRAIGHTEN A BENT YAMAHA RHINO FRAME
I would think that it would be cheaper just replacing the parts that need replacing and bill your friend for it later
559 views
Usually answered in minutes!
×