Question about kawasaki 2004 Bayou 300 4x4

1 Answer

Have a 87 300 buyou only habe spark when turn the key off and on changed coil cdi rectifire regulator

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 162 Answers

Kill switch ? ignition switch bad ? bad spark plug boot or plug?

Posted on Feb 21, 2019

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 7 Answers

SOURCE: no spark

It sounds to me like the repair shop has connected the ignition wire ( the wire going to the + side of the coil ) to the wrong switch terminal. Take a volt ohm meter and connect the ground wire to the negitive ( - ) side of the battery and expose the ignition switch terminals. With the switch in the OFF position check for volatge on all the terminals. Make note of any terminals showing a 12 volt reading. That is probably the feed line from your battery. Turn the switch to the ON or RUN position and check for a terminal other than the one which gave you a reading before. note and mark this terminal. Locate the coil. There are 2 thin ( 18 guage ) wires attached to the coil. One goes to the distributer and the other goes to the ignition switch. Isolate that wire and reattach it to the connection on the ignition switch you marked earlier...
Good luck,
shag79

Posted on Nov 29, 2008

  • 3567 Answers

SOURCE: no spark 110cc engine wont start

Check the fuses. Next, check for spark but with a new spark plug. How good is the battery? If needed, add water to the battery cells enough to cover the top of the cell plates.Try a jump start from your car battery. Is the kill switch on? Check the operation of the ignition switch with a volt ohmmeter. You should be getting power into and out of the ignition switch.

If the bike doesn't start and run properly check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. Broken or out of adjustment, it would kill the spark. Check for a broken wire at the switch or coupler. Get a service manual and check out the electrical section. Some bikes have a diode integrated into the turn signal relay. Try moving the kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it. If that doesn’t work, check out the relay.

Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center casing.

Please rate this answer. Thanks

Posted on May 28, 2009

  • 3567 Answers

SOURCE: 1983 yamaha xj 650 no spark already changed the

  • Do you see spark? If not, check the side stand kill switch. It kills the engine so that you don’t start out with the side stand down. If broken or out of adjustment, it would kill the spark. Check for a broken wire at the side stand switch and coupler. Try moving the side stand kill switch by hand. If that doesn’t work then wire a jumper around the switch to bypass it.
  • Is the handlebar kill switch on? Is it shorted out?
  • Are you getting power to the coils?
  • Check the fuses. How good is the battery? Try a jump start from your car battery.
  • Check the operation of the ignition switch and all kill switches with a volt ohmmeter. Check the wiring harness. Did a wire come unplugged? Are all wires clean and with solid connections? Any abraded or pinched wires? Is the bike in neutral and the neutral light is lit up? If no neutral light, check the neutral switch and neutral switch wire on center or side casing. If still no spark, get CDI system and coils checked at the dealers shop.

Posted on Aug 06, 2009

  • 5 Answers

SOURCE: ktm 450sxf 07 wont start

buy a yamaha

Posted on Sep 25, 2009

  • 1 Answer

SOURCE: bike wont fire. has no spark

I don't know what motor wires go to which???

Posted on Mar 22, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

04 Polaris predator, I bought used last week. I put a new battery and new carb on it. It doesn't have power, won't start, and no spark with kick starter. Dead. Fuses,wires, look good. Any ideas


Did it have compression before you bought it?
No power to the electric starter? Then you probably have no power to the ignition system. I'd check battery connections. Is the battery going flat overnight? Some shorts. Is there an ignition with a key? Is the switch good? or all the connections good? Corrosion does some funny things. Fuses may look good but actually are not.

Apr 02, 2015 | ATVs

1 Answer

I have a 1987 Honda 350 TRX foreman. When you turn the key it clicks several times and then will start if you turn the key and it does not click it will not start it will turn over but will not start....


Does the clicking sound you hear sound like the fuel pump pressurizing the fuel line? I am not sure if the TRX has a built in regulator on the fuel pump, or if it is separate, but it sounds like either the regulator or the pump, you can pick up most fuel pumps for ATV's on amazon for 20 to 30 bucks, I would try that.

Jan 02, 2018 | ATVs

1 Answer

Spark an I have no spark


Need to know what engine you have. You could have simple magneto ignition of CDI or ???

Nov 08, 2014 | ATVs

1 Answer

99 bear tracker


ok did you check for a good engine ground

Jun 09, 2014 | ATVs

1 Answer

Not firing how to check coil


Try to change your cdi box that's what I did

Jan 03, 2014 | ATVs

1 Answer

50cc apache quad spark problems


Could be the CDI. Check the stator and pickup coil specs with a multimeter first.

Nov 17, 2013 | ATVs

1 Answer

2005 kingquad 700 no spark put a new coil on no change


If there is no spark and you replaced the coil next step replace the spark plug dont assume its okay replace it!! next step is to get the CDI Box checked. Probably need to replaced that first.

Aug 17, 2013 | Suzuki 2005 KingQuad 700 4X4

1 Answer

No spark


check supp lie electricity to coil, if ok. but no spark. check ur ignite r in ur cdi box

Jul 01, 2013 | Yamaha 2006 Rhino 660 Auto 4x4

6 Answers

ATV will pull start but won't electric start? It just clicks...already replaced solenoid.


sounds like a dead battery, if not than its probably the rectifire. if you need me to help i can.

Jul 18, 2009 | RTO 125cc Full Size Adult Quad ATV

Not finding what you are looking for?
kawasaki 2004 Bayou 300 4x4 Logo

Related Topics:

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top kawasaki ATVs Experts

Jason

Level 2 Expert

218 Answers

Marvin
Marvin

Level 3 Expert

84027 Answers

Lawrence Oravetz

Level 3 Expert

10528 Answers

Are you a kawasaki ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...