2000 polaris sportsman 335 wont shift to reverse.

Uhav som computer or circuit issue..shud git it scand. Also somthin is worn n gittn hot lika relay..module etc. Buy a clymer or haynes shop manual

You very well could have the choke stuck or it could have a clogged muffler unbolt the muffler and start it and see if it will rev then

hard to shift gears - Polaris ATV Forum

www.polarisatvforums.com > ... > Polaris Sportsman

Jun 28, 2010 - my 06 500 efi creeps and sometime is a little hard to shift. the dealer told me ... inline. if its off a little when you are stopped and trying to shift the tranny has... 2013 RZR XP 900 .... shop, for first service and to put in a new belt, blew up the firstone already. ... what makes a polaris crew hard to change gears.

Won't shift with motor running. Need help please - Polaris RZR ...

www.rzrforums.net > ... > General RZR > RZR-S Specific Discussion

Mar 6, 2012 - It will not shift in any gear with the motor running, but if I turn it off I can.... First Name: Jeanie ... 2013 Grizzly ... LE - Muzzy, UMP, Donaldson, TS Seats, FixMyToys parts.. and a lot of hard work .... 2005 polaris sportsman 500 shifter problems stuck in reverse ... polaris ranger 700 crew wont shift when running. How to adjust shifter
Nov 27, 2013
Issue: In gear, but will not drive
Oct 22, 2012
Gear Grinding
Oct 7, 2012
HELP trans is hard to shift
Jan 26, 2011
More results from www.rzrforums.net

Ranger Problems & Solutions [Archive] - PRC Polaris

when changing oil usually you change the oil filter and there is a drain plug for the oil to out...i don't know bout the reservoir your talking about,,

sounds like linkage problem check linkage

My 2005 Polaris ATP 500 requires I depress the right foot brake while shifting into reverse or down into low range. Perhaps some adjustment on the foot brake to make this work. Also check linkage to make sure it is not binding. Others say if the idle speed is too high, you may not be able to shift. Try shifting with the engine off to see if it goes into the gears, using the foot brake. If yes, try again while at low idle speed.

shift solonoid going out.

If you need further help, reach me via phone at https://www.6ya.com/expert/allen_b068623c5003aa4b

remember on early models there was a safety pin that had to be held to switch to reverse,,,your 500 does this automatically so check for safety pin hookup. Could be brush or
grass jammed in where it moves.

With the engine NOT running, have a friend ROCK the bike forward and backward while you sit on the bike applying pressure to the shifter

The over RIDE button is not used for shifting.
it is used to over RIDE the REV LIMETER while in reverse ( for applications such as plowing)
shifting into 4wd while moving is safe on some vehicles, but can cause catastrophic damage on others.
be ABSOLUTELY sure your vehicle is designed for SHIFT ON THE FLY .
If you aren sure, then come to a complete stop befor shifting.