Slide carbs are very sensitive to float height I hear
SOURCE: 2006 toro,,tecumseh 6.5...prime,pull cord, starts,
Morning,, yes I did find the problem.. previous person that worked on it installed the main jet tube upside down. The Red one with the two "O" rings on it. I cut off the crimped end and opened the hole and reinstalled it and it started right up.... Thanks anyways....
SOURCE: My 99' gsxr 600 won't go past idle.
hi mate im prety sure these bikes have injectors rather than a carb
SOURCE: won't idle without choke, turn throttle boggs out
have u checked the float hight on the carburator? also make sure ur choke curcuit i clean and free of dirt
SOURCE: 2003 Honda Shadow Spirit VT750DC - Stock carbs,
Goto a bigger set of jets untill you find a set the cures the bog up.
The recommended jets are only a starting point.
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c
SOURCE: 2007 CRF 450 R- from
This can only be lack of fuel for some reason backfire is nearly always lean fuel condition and the cut out pretty much confirms lean or no fuel?
I would be checking the size of main jet (they numbered) double check it is factory size?
I would check the needle clip position god knows why but people change the position so double check it is factory setting (usually 3 or 4 notches from top is factory setting I forget which one it is for Honda's)
I would double check your air filter is clean and/or not oil drenched
refer to your manual or ring your Honda dealer for all the specs
Some other possibilities would be
spark plug fail at high load (but unlikely?)
stator failing at high RPM ( unlikely but worth the two minute multi meter test to make sure resistances is still in spec)
good luck regards Jamie
124 views
Usually answered in minutes!
×