Polaris problems LO 10,6

heres service manual -------https://www.manualslib.com/manual/1110612/Polaris-2013-Ranger-Rzr-S.html

T map sensor voltage to high or t map sensor voltage to low

No on the timing..sounds like the carb needs a professional cleaning.. and replace the spark plug!!

Not for sure, but if you belt is hot and you put it in H for HIGH then the gear multiplication may be such that it slips and won't pull because the gear is too high. By putting it in R for Reverse or L for Low you will get a lower gear ratio and it might pull the Rzr even though it is slipping. I would check the belt and the primary and secondary clutch adjustments.

Kthurst,Possible bad regulator code 168, did not find anything on code Is20230, links below to Polaris forum with good info.

• press the helpful button and follow me on fixya for more tips and info.
• 
  

Error Code 105 Polaris RZR Forum RZR Forums net

polaris code 520207

RZR 1000 Code chart Polaris RZR Forum RZR Forums net

hard to shift gears - Polaris ATV Forum

www.polarisatvforums.com > ... > Polaris Sportsman

Jun 28, 2010 - my 06 500 efi creeps and sometime is a little hard to shift. the dealer told me ... inline. if its off a little when you are stopped and trying to shift the tranny has... 2013 RZR XP 900 .... shop, for first service and to put in a new belt, blew up the firstone already. ... what makes a polaris crew hard to change gears.

Won't shift with motor running. Need help please - Polaris RZR ...

www.rzrforums.net > ... > General RZR > RZR-S Specific Discussion

Mar 6, 2012 - It will not shift in any gear with the motor running, but if I turn it off I can.... First Name: Jeanie ... 2013 Grizzly ... LE - Muzzy, UMP, Donaldson, TS Seats, FixMyToys parts.. and a lot of hard work .... 2005 polaris sportsman 500 shifter problems stuck in reverse ... polaris ranger 700 crew wont shift when running. How to adjust shifter
Nov 27, 2013
Issue: In gear, but will not drive
Oct 22, 2012
Gear Grinding
Oct 7, 2012
HELP trans is hard to shift
Jan 26, 2011
More results from www.rzrforums.net

Ranger Problems & Solutions [Archive] - PRC Polaris

New 2012 850xp won't start - Polaris ATV Forum

www.polarisatvforums.com > ... > ATV Repair and Maintenance

Jul 29, 2012 - With only 6 miles and 2 hrs on my new 850 the battery was dead. ...Location: Mc Minnville TN ... 2012 Sportsman XP 850 H.O. .... code 10.8 on a 2012polaris 850 four atv ... Copyright ©2000 - 2015, vBulletin Solutions, Inc. Broke my first axle
Apr 20, 2015
Sportsman 570 with or witout EPF
Nov 10, 2013
BRAND NEW 850xp PROBLEMS!
Oct 16, 2010
More results from www.polarisatvforums.com

Thread: Lo 10.8 code - Polaris Ranger Club

2011 Polaris Rzr ranger there is a fuse in line under the floor pan below the battery that gets corroded on the main wiring harness removed and relocated above the backseat try that you could buy one at Napa for under $10 try it I had the same problem with mine good luck

Solid state ignition has a capacitor that must charge and when the right time comes a SCR will dump the charge into the coil to make a spark. There is a minimum voltage that is required to trigger the SCR and at low RPMs that normally is close to being not enough. Most likely you will need to change out that CDI ignition or check the coil in the magneto, it may need to be adjusted closer to the flywheel.

A typical, fully charged & unloaded 12 volt lead acid battery should indicate about 12.6 V. Check the voltage / percent charge chart below:

Volts - Charge
11.7 - 10%
11.9 - 20%
12.1 - 30%
12.25 - 40%
12.35 - 50%
12.45 - 60%
12.5 - 70%
12.6 - 100

A fully charged that is only about 12V indicates a a problem with the battery - dead / shorted cells, etc. You can always remove the battery and have it tested at Autozone or similar auto parts stores if you're unsure. From the info you've provided - my guess is that the battery is "done"

I hope this was helpful - good luck!