Apache quad I have a 100cc apache quad that ticks over fine but when you give revs it cuts out anyone got an answer to solve it

Ah, it is a CHINESE Quad. Good luck with that and the after sales service. You can still try the search query I mentioned.

https://www.google.com/search?q=2008+Kawasaki+Brute+750+ignition+wiring+diagram

..

Adjust your idle speed up a bit. There will be a small adjustment screw on the carburetor, turn it clockwise a bit until the idle speed is good. If that does not work you could have a plugged idle circuit passage.

Wouldn't be a throttle cable issue. How long has the bike sat? If it was a while you probably got bad gas or gunk in the field line / filter / carb . Try loosing the fuel cap to eliminate the possibility of a bad vent valve not allowing air in the tank fast enough. Then if that isn't it and the gas isn't bad try flipping the fuel on off under the tank to reserve. If it works then your issue is a plugged on off res switch , next pull the fuel line off and blow through it. If it's plugged a little it'll be hard to blow through. Next step if not those is to remove the float bowl and inspect the float to see if it drops and rises without getting stuck if not then your gonna have to soak it in seafoam over night. One other issue that can be causing a problem is a loose ground. When the bike starts to move the ground may be shaking just enough to cut the power. Happened on my boat and darn near drove me crazy.

adjust cable or bleed hydraulics
problem can also be caused from dirty oil or incorrect oil in the transmission/ clutch pack

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manual works fine .

just guessing that you have already changed the spark plug??!! Handlebar on/off switch in the on position? (yes, I have seen this come to the shop). After this you need a shop manual to check wiring connections, resistance values..etc.. if not... might be shop time.

Could be the CDI. Check the stator and pickup coil specs with a multimeter first.

probably gas.

Go to easyquad parts technical help and you can download a wiring diagram for apache 100, this should be the same as what you need.

Probably a bad CDI check to see if it has spark if the CD I is bad count the prongs on on the plug go on ebay they are around 20 bucks depending on how many prongs are on the plug

If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386