When i start engine it will idle but when i press the throttle lever the engine die, when engine not running gas get into the oil, how do i adjust the carburetor what i need to do to fix the problem.
1st. Get the carb cleaned and set by a professional. Needle and seat might need replacing. If your spark plug comes out black and sooty looking, you need to also replace the needle jet and jet needle!
When engines not running turn the gas off . And it sounds like you need to adjust your throttle pin that goes into the carb take the clip off the pin and move it down one good luck
SOURCE: 49cc 4 wheeler
check fuel delivery & filter
check for dirty & or loose or boken coil wires
these coils are a problem on these little guys!
very cheap to replace though!
SOURCE: grizzly 660 will not start
Did you check the resistance on the stator? the stators are known to go out on the rhinos!
SOURCE: lower carburetor flexible gas outline is draining
sounds like your carb float is stuck and your needle and seat is open allowing the bowl to fill with gas and run out the overflow. take off the bottom bowl of carb and check to see if the float has a hole in it.
896 views
Usually answered in minutes!
×