kawasaki 2004 Bayou 300 4x4 Logo

Related Topics:

A
Anonymous Posted on May 23, 2012
Answered

The main 30amp fuse keeps blowing on our klf300

When we replace the fuse it blows instantly

Answer This Question

1 Answer

Spyro Matiatos

Spyro Matiatos

Level 2:

An expert who has achieved level 2 by getting 100 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Sergeant:

An expert that has over 500 points.

  • Expert 210 Answers
  • Posted on Jan 02, 2019
Spyro Matiatos
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Sergeant:

An expert that has over 500 points.

Joined: Jan 10, 2011
Answers
210
Questions
0
Helped
71675
Points
554

Follow it until you find the short. the wire may have rubbed raw against a metal part. Happens a lot. remove the fuse and put an ohm meter to the frame and to either side of the wire where the fuse mounts. It will tell you which direction from that point to follow

5 Related Answers

Anonymous

  • 6966 Answers
  • Posted on Nov 19, 2008

SOURCE: kawasai z750, keeps blowing main fuse

Hi,

To my knowledge, there are no onboard electrical/electronic components capable of shorting and blowing the fuse with out blowing any of the secondary fuse. The main fuse could possibly blow due to a short in the wiring or an exposed/frayed wire touching the body. The three most likely areas would be:

  • wire harness leading to the regulator;
  • wire harness leading to the fusebox; and/or
  • wire harness leading to the ignition switch.
Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.

Ad

Anonymous

  • 120 Answers
  • Posted on Jan 06, 2009

SOURCE: JVC RX-318 keeps blowing fuses

could be several things, speaker wires touching,shorted output transistors, a shorted rectifier diode,bad filter caps in the power supply,those are the most common

Anonymous

  • 66 Answers
  • Posted on Feb 16, 2009

SOURCE: 30AMP FUSE KEEPS BLOWING WHEN I CONNECT THE BATTERY

i have had that happen when i accidentally hooked cables backwards to battery.red cable(pos) to post w/ + next to it & black cable(neg) to post w/ _ next to it is correct.

ginocussen

Gino Cussen

  • 217 Answers
  • Posted on May 22, 2009

SOURCE: gsxr 600 1999 keeps blowing main fuses.

My guess is the wiring around the headstock pivot are shorted out, and you will need to need to do a check with a meter. This manual should explain clearer....
http://www.carlsalter.com/download.asp?fileid=083117122117107105095071083088045082054048048095039057055045048048095083101114118105099101095077097110117097108046112100102

Rate me if I helped
Thanks.

Anonymous

  • 32 Answers
  • Posted on Aug 10, 2009

SOURCE: My 2006 keeps blowing her main fuse!

Most likely it is getting grounded out somewhere, or just bad wiring. Hope i was of help to you!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
3answers

2003 kodiak 400 2x4, as soon as the ignition key is turned on the 30 amp fuse by the blows.
You have a dead short . Disconnect the battery , set your volt meter to read ohms and send a current from each position on the ignition switch to the fuse block where the fuse is blowing . You should be able to trace the problem quite quickly .
Read full answer
Dec 25, 2018 • Yamaha 2004 Kodiak 400 Auto 4x2
0helpful
2answers

Kawasaki mule 610 blowing fuses what could be causing this , 2013 ?
Had a mule which blew main fuse every time I put in reverse. Turned out the back up switch was shorted. If you can tell at what point the fuse is blowing, may help find the problem.
Read full answer
Aug 10, 2018 • ATVs
0helpful
1answer

2006 artic cat prowler blows 30amp main fuse when stator harness is pluged in
dead short in stator
replace it
Read full answer
Nov 30, 2017 • ATVs
0helpful
1answer

Borrow ATV to do some field spraying but it keeps blowing the 30 amp fuse. Sprayer on its own power. Replace fuse, runs for a couple of minutes then blows, thoughts?
Check the rated amp draw on the sprayer. It might be rated higher.. If the sprayer is wired with too small wire it might be causing too high an amp draw..see if the wires are hot? How is the sprayer grounded? Make sure ALL the wire connections are clean and tight. Use a blade type fuse in a waterproof holder. Recheck all this and repost with the results.
Read full answer
May 28, 2017 • ATVs
0helpful
1answer

Keeps melting the fuse case but doesn't blow the fuse
Maybe you dont have the right size fuse installed. It shouldnt get the wires that hot befor it blows the fuse.
Read full answer
Aug 23, 2015 • ATVs
1helpful
1answer

Atv trouble shooting
Whoops, can you tell me why you changed the fuse and what happened before that, and are you sure it wad a 30 amp that's awfully high, what was the fuse for on the machine, and sometimes it will blow fuses if they are too high not good, and plus doo you have any accessories you have added to the machine? Might be battery not grounded, like if it gets wet will blow the fuses, and an overload of amperage more details unless this helps ya
Read full answer
Sep 03, 2014 • kawasaki 2011 Prairie 360 4x4 Camo
0helpful
1answer

Why would my commander Keep blowing the ignition/injector fuse?
Disconnect and clean all the earth wires, never use a higher than recommended fuse or you may have a fire.Check for rust on the earth wires also.
Read full answer
Aug 05, 2014 • Can-Am Care 2012 Commander 1000
1helpful
1answer

What would make the fuse under the seat keep blowing
There has to be a short in the line somewhere in order for the fuse to constantly blow. A wire has rubbed against some steel and is causing the fuse to blow. trace the fuse to the link....such as the lights or rear light and check the socket or wiring for a short.
Read full answer
Aug 03, 2014 • Polaris 2010 Sportsman 90
0helpful
1answer

Loncin 90 cc atv blows main fuse when i try to start doesn't even turn over.Turn key to on lights work but soon as i hit start button blows fuse.I bought this off a friend I noticed that its missing the...
could be a bad solenoid or the wire going to the solenoid is bare and touching frame somewhere
Read full answer
Oct 01, 2017 • ATVs
0helpful
1answer

I have a 2008 Polaris Sportsman 500 X2 H.O. EFI, After about 1 to 1.5 hours of riding the main fuse will blow, if you put a new fuse in it will idle but touch the throttle and the fuse will blow again,...
I would look for any excessive water or moisture hidden in an electrical component, or corrosion in any connection points..
double chech that you are using the correct amps fuse
Read full answer
Dec 06, 2017 • Polaris ATV
Not finding what you are looking for?

View Most Popular

2004 Bayou 300 4x4

  • ATVs

Related Question

2003 kodiak 400 2x4, as soon as the ignition key is turned on the 30 amp fuse by the blows.

  • Yamaha 2004 Kodiak 400 Auto 4x2

1,944 views

Ask a Question

Usually answered in minutes!

Popular Questions

Carburetor adjustments bayou 300

kawasaki 2004 Bayou 300 4x4

Kawasaki bayou 300 will not run with out choking it

kawasaki 2004 Bayou 300 4x4

How do I find vin number on klf 300 quad bike.

kawasaki 2004 Bayou 300 4x4

How to adjust a clutch on Kawaski 4wheeler Bayou kif300f 4wd

kawasaki 2004 Bayou 300 4x4

Install a stator in a 1995 kawasaki bayou 300

kawasaki 2004 Bayou 300 4x4

Top kawasaki ATVs Experts

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Renee Knafel-Bullock

Level 3 Expert

404 Answers

Are you a kawasaki ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...