Kymco 2005 MXU 250 - Answered Questions & Fixed issues


check the pickup coil and the wiring for the shut off switches. if one rubs and grounds itself on the frame it wont spark.

Kymco 2005 MXU... | Answered on Feb 14, 2017 | 359 views


It could b coil, valves need adj, plug, bad fuel, plug cap, cars need cleaning or rebuilt

ATVs | Answered on Jun 15, 2019 | 38 views


when was the last time it was serviced? could be any number of causes?

ATVs | Answered on Jun 12, 2019 | 22 views


Float adjustment is critical! Your local dealer will have the correct spec's to set this by. ..Too low and you will run lean... too high and you will leak/overflow fuel!!

ATVs | Answered on Jun 11, 2019 | 59 views


you need a special tool from Polaris

ATVs | Answered on Jun 11, 2019 | 63 views


I would not be too concerned...I change belts every two years under normal conditions..... cheap insurance...

ATVs | Answered on Jun 11, 2019 | 30 views


Flush it with what>>??? NO!! Why?,, Did you sink it? Drain the oil and let it drain for several hours.. refill it with the correct amount of the correct oil... ride it until it gets hot ..then for about 30 more minutes, and then change the oil again..refill with correct amount of recommended oil and you should be fine..

ATVs | Answered on Jun 11, 2019 | 38 views


Which ATV... too many different models to answer this question.. refer to your owners manual..

ATVs | Answered on Jun 11, 2019 | 29 views


My first thought is air leak... at carb manifold/gaskets/etc.. second is leaking head gasket.. or maybe - possibly- the carb itself.

ATVs | Answered on Jun 11, 2019 | 21 views


Sound like it's out of time or valves arnt closing all the way

ATVs | Answered on Jun 10, 2019 | 20 views


Had one not to long ago that had the splines on the shifter shaft rounded of of it to were the shifter leaver when push or pull on it leaver would move but the shifter shaft would not I drilled a hole through the both of them and put a roll pin in in now such problem

ATVs | Answered on Jun 10, 2019 | 23 views


need a meter to test the electrical system for a short or a failed component

ATVs | Answered on Jun 08, 2019 | 17 views


Sounds like its not getting fuel to the back cylinder ,check that the valve gear is working properly in the back cylinder

ATVs | Answered on Jun 05, 2019 | 27 views


It is located on the left side of the motor behind the flywheel.

ATVs | Answered on May 30, 2019 | 26 views


check and test fuses relays and connections winch is direct battery hook up --check ignition ---neutral /park --kill switches

ATVs | Answered on May 29, 2019 | 23 views


dealer service repair shop in your area or online search

ATVs | Answered on May 29, 2019 | 28 views

Not finding what you are looking for?
Kymco 2005 MXU 250 Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Kymco ATVs Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

 Scott Tx
Scott Tx

Level 2 Expert

604 Answers

john h

Level 3 Expert

21325 Answers

Are you a Kymco ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...