Kymco 2004 Mongoose 50 - Page 3 - Answered Questions & Fixed issues
I have a 2006 Polaris sportsman 800 twin with efi diagnostics and when I drive the quad it’s sounds fine but when it starts to turn on the cooling system a loud rattle turns on and it gets louder when I turn the wheels, the noise is coming from the front
The loud rattle that you hear when the cooling system turns on and when you turn the wheels may be caused by a few different issues. Here are a few possibilities:
- Loose or damaged components: It's possible that a component in the front of your Polaris Sportsman, such as a fan blade, is loose or damaged and is causing the noise when the cooling system turns on. Check all components in the front of the vehicle to make sure they are secure and not damaged.
- Loose wheel or steering components: The noise may also be caused by loose wheel or steering components, such as a wheel bearing, tie rod end, or ball joint. These components can become loose over time and can cause a rattle or clunking noise when driving or turning. Check these components for wear or damage and tighten or replace them as necessary.
- Engine or transmission issue: It's also possible that the noise is coming from the engine or transmission and is being amplified by the cooling system turning on. Have a mechanic inspect the engine and transmission to determine if there are any issues that need to be addressed.
It's important to address any unusual noises in your vehicle promptly to prevent further damage and ensure safe operation. If you are unsure of how to diagnose or repair the issue, it's best to seek the help of a qualified mechanic.
2/26/2023 3:55:20 AM •
ATVs
•
Answered
on Feb 26, 2023
•
232 views
How to change coolant in a 2008 Kawasaki diesel 3010
1. Park your mule on a level surface and remove the drain plug from the bottom of the radiator using a socket wrench. Drain the coolant into a pan or onto the ground.
2. Remove the radiator cap and top off the radiator with fresh coolant to the level indicated on the side of the tank.
3. Install a new coolant filter on the coolant lines.
4. Add the appropriate amount of coolant to the radiator and make sure that the level is where it should be.
5. Reinstall the radiator cap and drain plug, then start the engine and let it run for several minutes to allow the new coolant to flow through the hoses.
6. Let the engine cool, then check the coolant level again. Add additional coolant if necessary.
7. Replace the coolant filter once a year to ensure that your engine stays in top condition.
2/22/2023 7:16:34 PM •
ATVs
•
Answered
on Feb 22, 2023
•
139 views
I have a 2004 sportsman 500 HO, where is the fuse box located
The fuse box on the 2004 Sportsman 500 HO should be located under the hood, near the battery. On the left side of the battery box, look for an access panel with a fuse cover. This cover will provide access to the fuse box.
2/14/2023 10:01:27 PM •
ATVs
•
Answered
on Feb 14, 2023
•
1,729 views
Fuse box location on 1999 polaris mag 500
The fuse box should be located near the battery. It is usually near the front fender. The cover should have a diagram of the fuse layout, which should tell you what fuses are located in the box.
2/14/2023 9:58:27 PM •
ATVs
•
Answered
on Feb 14, 2023
•
1,576 views
2005 eton atv viper 90r 2 stroke engine dies when put in gear
This could be caused by a few things. There could be an issue with the clutch, the CDI (capacitor discharge ignition) unit, or the ignition coil. You may need to have a mechanic inspect the components to determine the exact cause.
1/10/2023 1:05:54 PM •
ATVs
•
Answered
on Jan 10, 2023
•
141 views
Not finding what you are looking for?