20 Most Recent Kymco 2008 Mongoose 250 Questions & Answers


Hi Matt only help I can give is look along top & bottom of chain for a tensioner it will be a round rubber wheel. If you cant find a tensioner it will more than likely you need to cut the chain down. If your not sure how to let me know & i'll let you know how. Also DO NOT USE IT while chain is loose as if you do & chain comes off you can crack engine case which then means a new engine

Kymco 2008... | Answered on Jan 23, 2014


do you have internet where you live? Try this
"2002 Polaris trailblazer users manual"

ATVs | Answered on Oct 16, 2019


Yea, what you said == just google it.

ATVs | Answered on Oct 16, 2019


Usually, there is a hole plug near the bottom of the casing. BUT first drive it around a lot cause gear oil is heavy and it won't come out very fast if it is cold.

ATVs | Answered on Oct 16, 2019


power to efi module? no, find where it stopped and reconnect.
yes, power out of efi module? no, replace efi module.
yes, open between efi and pump.

ATVs | Answered on Oct 16, 2019


search engine are more efficient. If this isn't to your liking
https://taotao.zendesk.com/hc/en-us/articles/204167645-General-Torque-Spec-Settings-
try searching "clutch nut torque spec"

ATVs | Answered on Oct 16, 2019


I don't understand your problem. What is a "make end"?

ATVs | Answered on Oct 16, 2019


are you into troubleshooting? Probably not, but one must have fuel, ignition, and air to make things burn or run an ICE.
What don't you have?
Is there an ignition source? Did you pull the spark plug and verify it will spark?
Is there fuel? No, not in the tank, it must be getting to the engine.
Is the spark plug wet? If it isn't wet with fuel, you are not getting fuel.
Is there air? No, not what you are breathing, but getting to the carburetor. Did you check the air cleaner?

ATVs | Answered on Oct 16, 2019


It acts like you have burnt spots on the starter shaft that touches the brushes ( voltage) to start. When you rock the vehicle in gear the starter shaft moves and it is placed in a position where the brushes can make a clean contact. Then when you turn the key, the starter will engage and the vehicle will start. My recommendation would be to change out the starter.

ATVs | Answered on Oct 15, 2019


check wire harness for short

ATVs | Answered on Oct 10, 2019


It sounds as though your ignition switch is not hooked up correctly. Follow the harness from the ignition switch to the bullet connectors under the front body plastic. Make sure the colors all match up.

ATVs | Answered on Oct 08, 2019

Not finding what you are looking for?
Kymco 2008 Mongoose 250 Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Kymco ATVs Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

 Scott Tx
Scott Tx

Level 2 Expert

604 Answers

john h

Level 3 Expert

22423 Answers

Are you a Kymco ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mongoose 250 Kymco

  • Mongoose 250 Kymco

Most Popular Question

tighten chain kymco atv

  • ATVs
Loading...