20 Most Recent
Kymco 2010 UXV 500 4x4 - Page 2 Questions & Answers
I need a wiring diagram for a Polaris 600 twin Sportsmen
limited info generic answer ---this is a free download for an 04 [didnt specify year ] do an online search using yr make modle engine and should be able to find a manual for your atv =======https://www.scribd.com/doc/50591229/Polaris-Atv-2004-Sportsman-600-700-Service-Manual
10/14/2023 12:19:57 PM •
ATVs
•
Answered
on Oct 14, 2023
Can you tell me where the pickup coil to the stator on a 1994 arctic cat 440 is?
In the 1994 Arctic Cat 440 snowmobile, the pickup coil to the stator is typically located within the engine's magneto or flywheel assembly. This component plays a crucial role in generating the electrical impulses needed for ignition and other functions. It's comparable to how understanding the intricacies of a snowmobile's engine components is essential, much like comprehending the stages of pregnancy is crucial for cat breeders. For instance, breeders referring to a resource like "
https://mysilverbengal.com/silver-bengal-cat-pregnancy/" can gain valuable insights into the various stages and care requirements of a silver Bengal cat's pregnancy, ensuring the health and well-being of the feline and its offspring.
8/28/2023 7:10:12 PM •
ATVs
•
Answered
on Aug 28, 2023
How to add push button start switch on 2005 Kawasaki mule instead of the key switch
To add a push button start switch on a 2005 Kawasaki Mule instead of the key switch, you will need to follow these steps:
1. Remove the key switch from the dashboard of the Mule. This can be done by unscrewing the retaining nut on the back of the switch and pulling it out of the dashboard.
2. Locate the wires that are connected to the back of the key switch. There should be three wires: one red wire, one black wire, and one green wire.
3. Cut the red and black wires, leaving enough length on each end to connect them to the push button switch.
4. Connect one end of the red wire to one terminal on the push button switch, and connect one end of the black wire to the other terminal on the push button switch.
5. Connect the green wire to a ground point on the Mule's chassis. This will typically be a bolt or screw that is connected directly to metal.
6. Test the push button switch by pressing it while turning on the ignition. If everything is wired correctly, the Mule should start up without any issues.
It's important to note that this modification may not be legal in all areas, so be sure to check your local laws before making any changes to your vehicle's ignition system.
6/21/2023 7:14:29 PM •
ATVs
•
Answered
on Jun 21, 2023
Not finding what you are looking for?
