kawasaki 2005 Mule 3010 4x4 - Answered Questions & Fixed issues

I bet you have a nylon bushing that has gotten brittle and disintegrated. Your local Kawasaki dealer should have an exploded view of your machine. Look to where the linkage and cable meet on both ends.

aparently not an uncommon problem. here is some read https://www.justanswer.com/motorcycle/cb9d0-kawasaki-mule-2510-makes-grinding-noise.html

most wheel bearings are just snug tight so the wheel does not rock on the bearings. they have rollers that need to roll.

Gear driven internally.

Did you drain the carburetor at the end of the season, or shut off the gas valve and run the carburetor dry? If not, the issue is probably varnish and gum from the evaporated gas plugging up the carburetor. You will have to pull the carb apart and clean it.

It sounds like it needs to be adjusted or something in the transmission stripped, have you checked the rear axle and bearings, if that is the issue i think yo can get a axle and bearings for$250-$275

Check for a fuel obstruction, sounds like urs starving for fuel, test or check your lines, fuel pump, any valves, etc are free and clear. I hope this helps!

Front right side by filter.

I believe its mechanically set so no need to re time it when replacing electrical components.

Sounds like not getting petrol, clean petrol tap to get a good flow and clean and strip carburetor the needle and seat could be clogged any way clean and blow out jets and holes with compressed air put back together and away you go.

bad ground be my guess loose wire ?

Hey Keith, get a manual.. its easier than trying to "diagnose" on here.. Sorry..good luck.. kawasaki mule 1000 450b1 repair manual Google Search

Hey Dennis, there is no way to tell what part number(s) you need.. this is not a complicated repair, but does take some knowledge.. if you are not very good, mechanic wise, I would find a qualified professional to help with it...it has to be RIGHT,, or it will break again..

What is the compression? This leads me to think you may have more of an internal issue. Have the compression checked, with throttle wide open, then repost with the results.

Full tune up and carb clean .get new plug,air filter.oil Chang ,carb clean and adjustment.that should do it.,., try fuel filters and test fuel pump see if it's functioning properly.,.

Check your fuel filter! Fuel not being filtered properly is the main cause of fuel pump failure.

Hi ! for an informantion, please visit the website below. If you need more information about a specific electrical issue you can reach me at [email protected]. http://www.motorpartstore.com.Good luck and have a nice day.

This was due to the specific circumstances, and if you are interested in motorcycle accessories, you can try to look into this website http://www.motorpartstore.com.Good luck and have a nice day

Hi ! for a free wiring diagram, please visit the website below. If you need more information about a specific electrical issue you can reach me at [email protected]. http://www.motorpartstore.com. good luck and have a nice day.

pump is suffering excessive oil pressure you are very short on the details of the failure --broken shaft , gears , chain housing etc but I would be checking oil passage blockages, faulty pump pressure regulator spun bearing that the pump feeds into the oil galleys