Top 20 kawasaki 2005 Bayou 250 Questions & Answers

what year ? 1999 should be 15 to 20 mm intake on exh 18 to 23 mm i think depending on year. they run tight. adj at tdc on comp stroke with valves open far as they can. have to rotate eng for each valve to open fully and independently one opens and other closes at same time. should be very quiet if adj correctly.adj the closed valve only when fully closed

I suggest you check the exhaust isn't partially blocked and then if OK ensure the cam timing, valve clearances, etc. is correct.

buy a replacement barrel and key off ebay,be lots easier

google your model for schematics and locations of parts.

YES!

first I'd clean the carb, new spark plug. I've seen a bad cdi cause that but thats the last thing I'd check cause $$$

Did you check the frame rail by your left toe? it may have been painted over.

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U can also get free manual works fine .

Have you tried to lower the idle? When an Auto/5speed shiftable transmission is stopped in gear the drivetrain holds it back or loads it down a bit. If you take off a load the idle will rise. Sounds like your idle is too high. Do you have your idle set high to keep it from stalling?

the solenoid has gone bad most likely. if that checks ok, could be the keyswitch, kill switch or neutral safety switch.

T is usually the mark on the flywheel and there's usually a mark on the cam sprocket and head to line up. you can google up a service manual too most likely.

a large hammer and lots of effort. if the center has come out you can cut the outer ring with a dremel cutting disc.

good luck.. Kawasaki bayou 300 service manual free download vbou

How do you know they are gas lines? Are they the same diameter? Why are they not still connected?Does this ATV have a fuel pump? If so they probably connect to the pump.. one is the fuel line and one is a vacuum line... the other probably an overflow.

check kawieriders dot com

clean your carb, check for compression.

thats normal. probably a bad wire in the cable and by taking it off you made it reconnect.

Try a new battery

Hi ! for an informantion, please visit the website below. If you need more information about a specific electrical issue you can reach me at [email protected]. http://www.motorpartstore.com.Good luck and have a nice day.

Depending on the amount of metal in the oil would dictate the seriousness of the issue. A little is ok in most cases in the first few oil changes, but anything more than that and there is something wrong with the engine. In most cases this would mean a total rebuild.