20 Most Recent
RTO 200cc Full Size Four Wheeler ATV Questions & Answers
Wiring polaris trail blazer 250 diagram
There are several places you can go on the web that have free atv repair/owners manuals. The owners manuals usually have a wiring schematic on or towards the last page also trouble shooting diagrams with instruction in them.Type in your search bar: atv polaris (year) model:trailblazer/500cc.If you like email:
[email protected] with specs and I will email it to you.Hope this was helpfulTry2B8me
I have 2000 quad runner 250 ran fine for most of
If it turns over fast it is not the battery or charging system. If it turns over fast but does not like to start when motor is warm it is probably running rich. If it ran good before and the carb has not been messed with i would check the air filter. It needs to be nice and clean.
I have a honda TRX 350 2000 model quad and the 4wd is not working, any ideas?
Your 4 wheel drive may be working, but it is a torque-sensing front
differential for reduced steering effort, that supposedly sends power to the wheel with the most traction. Many owners have found that just the opposite is true. Your problem may mean that the differential is working, but because it doesn't lock up both tires in the front and only one tire is getting all the traction you can't see it work as advertised. The link to the video is great for showing what may be happening. The front differential may be worn out and need to be fixed or it may just be that it is not working as you expected:
https://www.youtube.com/watch?v=KF-iD4pmmoA
Why wont my rubica 4 wheeler go in reversa
If you have a Honda Rubicon, you must place the transmission in Neutral, then pull in Left Hand brake and push down Reverse knob that will remove the reverse lockout and allow you to shift it into reverse. If that doesn't work your reverse lockout knob might be defective or out of adjustment. The adjuster, depending on which model you have, will be on one end of the reverse lockout cable.
MY HONDA FOURTRAX WAS VERY LOW ON REAR END OIL AND
I purchased a 2000 Honda Foreman 4x4 and changed all fluids. I put synthetic differential oil in the front and rear differentials.
The problem I am have after about 6 months is the front wheels are not pulling like they use to.
Before I changed the fluids with the front wheels jacked up I could not turn the front wheels but now with very little effort I can turn the front wheels.
Did I make a mistake in using the synthetic oil and if so what is my recourse?
When I push the starter button the solenoid
Just because it's new, doesn't mean it works.
This is why cars get recalled.
The iron-clan test of a non-working solenoid is to cross the relay terminals. If you do and it starts.. it's bad.
Take it back. you purchased a dud. It happens.
How to remove a needle and seat out of a ymaha kodiak 400
Take the float bowl off the carb. Pull the pin that holds the float on. The needle is attached to the float. The needle just came out of the needle seat. The needle seat can now be pulled out. This is the fun part. Are you really sure it need replaced? If it is needing a good cleaning, take some Mother's aluminum polish and a cotton swab and put it in the seat and spin the heck out of it. It will polish up nice. Be sure to clean with carb cleaner to get any extra polish out before use.. reassemble.
Not finding what you are looking for?