20 Most Recent RTO 125cc Full Size Adult 4 Wheelers ATV Quads Questions & Answers

You need to first determine whether the problem is fuel or electrical. Remove the sparkplug and pour in a small quantity of gas. Replace sparkplug and high tension lead. Crank it over. If it does start and run a bit then your problem is fuel and not electrical. If it does not fire and the sparkplug is wet, then start be replacing the sparkplug with a new one.

If it is ticking the starter solenoid is bad or the battery has low voltage If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

go to youtube and look for polaris belt changing vids. its pretty easy and they're all similar.

your idle air mix might need adjusted. also look for air leaks between carb and air filter

only thing left is compression.

Go to an atv dealer & ask about manuals

follow the wire till you find the short then tape it up or cut it where its damaged and do it right by using a heat shrink wrapping they make to go around the wire you can use a lighter instead of heatgun but keep flame away a bit

Could be the shift shaft assembly... needs professionl attention

I am not sure what you mean to "Reset" the carb is it leaking? or flooding the engine out? need more info before I go into explaining how to rebuild the carb

Go up 2 sizes on the pilot jet that's the little jet next to the main but before you change sizes make sure that it's not plugged up hope this helps you If you need further help, I’m available over the phone at https://www.6ya.com/expert/brandon_79b580f5a99c4386

You seem to have many problems with this ATV reading the different postings have you checked the compression on all 4 cylinders if so what were the readings ?

does it have gas is the fuel turned on does it have spark is the battery good does it crank you have to try a little harder to get proper help !!!

blocked fuel line, blocked fuel filter, petcock is closed.

take off the horn unit power it direct if it works its ok, if not replace, next step wire a small bulb into the horn wires and press the button if it lights the switch is ok, if you have a circuit tester put one end on the battery ground and check for power in the horn wires if their is power there put the lead on battery positive and press the horn button if there is no power their the switch or wiring is faulty