Kymco UXV 500 4X4 - Popular Questions, Answers, Tips & Manuals

, usually due to a leaking fuel line or malfunctioning fuel injectors. However, it is normal for a small amount of gas to get into the engine oil during normal engine operation.

belt drive ? or chain. ? belt slipping ? sprocket on chain loose?

fixya doesnt sell products try recreation action repair shops or online

Check out this site for your manual https://searchmanuals.net/search7/?keyword=%2Bowners+%2Bmanual&gclid=Cj0KCQiAzePjBRCRARIsAGkrSm4hwGgMJ4loxVKnk_d9loNSyMnzjcinCTYKx6DBNotuk4W7EdNURhoaAggqEALw_wcB

Same problem with my mxu 500. Charged battery. Nope. Checked all connections in starting system. Nope. Swapped out solenoid relay. Fixed mine. Was cheap online- less than $20. Mine would start with jumper cables or batt charger on 80amp boost. Good luck!

whats the old plug look like? google for images to tell you whats going on.

float height or dirty float needle

belt slipping needs new one as it wears jus the edges

This is a 500 4x4 and the fan is not coming on all the time causes it to run hot it's a 2012 done put new radiator and sensor on it used it yeasterday and had trouble with it could somebody please point me into right direction

Is it a battery powered vehicle? Email me at [email protected]

Question edited for clarity. Question moved to model category.

no spark.

KymcoForum.com https://www.kymcoforum.com > ... Jan 10, 2015 - Try un-plugging the rectifier, and see if you get spark. It may be shorting the stator to ground. Also try clipping the black, and yellow ... Power to coil but no spark. What can it be? Jun 11, 2016 Kymco 150 bogging down Mar 27, 2014 wiring schematic for 05 mxu 150 Jun 23, 2014 suspected faulty kill switch Jan 16, 2015 More results from www.kymcoforum.com

No Spark At Spark Plug - KYMCO MXU 150 Service Manual

ManualsLib https://www.manualslib.com > ... > Service manual KYMCO MXU 150 Manual Online: No Spark At Spark Plug. Inspection/Adjustment ... Check ignition coil with. a CDI unit tester. 1-37. Symptom. Weak or no spark. Not ... Missing: 2007 ‎' Show results with: 2007

KYMCO SERVICE MANUAL

ATV Scooter Parts https://atvscooterparts.com > atv > mxu150-m Jun 8, 2005 - No power. Intermittent power. • Dead battery. • Loose battery cable ... LIGHTS/ SWITCHES. 17-6. ATV 150/125. MXU 150: INSPECTION. Disconnect the ... 244 pages ..

Visit the on-line store, know as https://www.heavy-equipmentmanual.com/, they have the repair manuals. I'm sure you will get the solution of your problem.

Check the ignition switch for continuity. When you switch off, there should be no continuity to the ignition.

There could be a few issues causing your ATV to not start and the neutral light not to come on. -The neutral switch could be faulty and needs to be replaced. -The starter relay or starter solenoid could malfunction and needs to be checked. -The battery could be dead or not holding a charge and needs to be replaced. -A faulty ignition switch or wiring issue could also be the problem. It is recommended to take it to a mechanic or dealership for proper diagnosis and repair.

choke it ? gas not getting to piston air filter clogged ?

meter wont change

Installing a hardtop on a 2014 Kymco UXV 700i ATV may vary depending on the specific hardtop you have. However, here are some general steps you can follow:

1. Gather all necessary tools and equipment, including a drill, screws, and any other hardware that comes with the hardtop.
2. Place the hardtop on top of the ATV and align it with the mounting points.
3. Use the provided hardware or screws to secure the hardtop to the ATV. Make sure the hardtop is securely attached and level.
4. Check that all screws and bolts are tightened properly and that the hardtop is securely attached.
5. Test the hardtop to ensure it is properly attached and does not move or shift while in use.

It is recommended that you refer to the installation manual that came with your hardtop for specific instructions and to proceed with caution to not cause any damage to your ATV.

general rule of thumb if you cant find specs is make the float parallel with the bottom of the carb/top of the bowl

Try rocking quad toward and back while you try to shift out of park.

check the pickup coil and the wiring for the shut off switches. if one rubs and grounds itself on the frame it wont spark.